Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Quick one, what do the three LEDs on the 1232AG access point indicate? I assume its the usual status, activity, etc. but in what order? The documentation does not include this info!Thanks

darrenj by Level 5
  • 585 Views
  • 1 replies
  • 0 Helpful votes

Anyone out there have an istallation guide for one of these? I have acquired one for home use and need to default it so as I can set security on it. Any help would be appreciated.

someone mentioned to me today this to me today and I can't seem to locate any information on the cisco website regarding it. supposedly its a new access point that function like a thin client? does anyone know what this is called or anything about it...

aletoledo by Community Member
  • 499 Views
  • 1 replies
  • 0 Helpful votes

I've successfully upgraded one of my Aironet 1100 APs from 12.2(13)JA4 to 12.3(7)JA. However, when I associate a device to the AP I cannot pull an IP address from my DHCP server. The AP is on the same segment as my server DHCP, so there is no routing...

eric.jordan by Community Member
  • 768 Views
  • 2 replies
  • 0 Helpful votes

We have a bridge up and running that occasionally drops, the timing of the drops is not consistent, so doesn't appear to be a timer per se.Here are the Dot11Radio config'sRoot Bridgeinterface Dot11Radio0 no ip address no ip route-cache ! ssid tsunami...

mothdiver by Community Member
  • 2625 Views
  • 7 replies
  • 0 Helpful votes

Hello,I have two questions in regards to the Aironet 1000 power injector, so I thought I'd bundle them into one. Question 1:Reading from the datasheet at this link:http://www.cisco.com/en/US/products/ps6306/products_data_sheet0900aecd8025708a.htmlIt ...

elsamadrigal by Community Member
  • 1229 Views
  • 1 replies
  • 0 Helpful votes

hi.....requests ur help in following..i want to configure two 1100 APs as a part of existing LAN...how i should i configure them..should it be multicell or root/repeater model users should be able to roam and get connected to the nearest AP to them w...

Unable to boot WLSE 1130-19 after upgrade from 2.9 to 2.11 .could u give me the Kernel version for thisI need to supply the Grub parameters to boot the WLSE.

raviramesh by Community Member
  • 540 Views
  • 1 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card