Wireless

Has anyone had any experience with SOX and proving the fact that you're doing 802.1x authentication on your WLAN? I need to find a way to show that all of my APs are configured to do 802.1x only. I have the WLSE, but can't find a definitive way to pr...

Has anybody seen clients showing up as repeaters on the Access point?I have a 1230g, and 350 (upgraded to IOS) in a remote office. Both are using LEAP and authenticating back to Cisco ACS server. I have 3 or 4 clients that are showing up on the WAPs ...

I have been trying the Aironet Client Utility V6 and I can't find any feature that 'scans' for available wireless networks. Does this software have anything like that? I can't imagine any wireless software not having a scan feature.

Can Leap auth against more them one database for a two layer auth?

WLSM uses GRE tunnels to clients and it works well.But I'm running into a nagging fragmentation problem which causes problems with web pages - they don't load.Current workaround is to lower MTU on the client which makes it very difficult to roll out ...

Can I setup my Aironet 1200 to use TACACS+ for authentication back to the cisco ACS server and RADIUS back to same server for user authentication? If I setup a server in Server Manager under Radius, then add that same server as a TACACS+ server, it d...

Hi there,As far as I understand the 1400 is not available for install in the UK. Does Cisco know when we will be able to install this product in the UK?So far only Ireland is available or am I quote old news???Thanks

Hello,I just upgraded last week to WLSE 2.11u and I have this new message appearing in the faults display:Inconsistent state found for query "interface.radio.config"The devices are two Bridges 1310 running 12.2(15)JA. haven't found anything unusual w...

does anyone familiar with this message on the wlse faults - "Inconsistent state found for query "interface.radio.config"thanks

Hi,Does anyone know if Cisco has a site survey utility for 802.11G standard?regdsJohnny

While upgrading the AP1100 firmware, network connection to the AP was disrupted. Thereafter, the AP is not accessible and the radio and status LED is red indicating a file system failure. I tried reloading the image by pressing the MODE button but st...

HelloI am trying to connect an AP1100 in station workgroup-group bridge associate to another AP1100.Without any authentication (authentication open) nad with static wep128 is everything fine. When I try to use leap then the AP1100 in wgb modus failed...

helloUsing BBSM5.3 i discovered local Access points (1100).when making room mapping, i noted each AP has just one port. we can't define more than one room per AP.can you confirm this issue.thanks

Can someone give one example about calculationparameters for use voice over wireless ?Is this equal to voip over ethernet or not