Wireless

anyone else having issues with these cards seeing the access points?AP IOS 12.3.4-jaRadio firmware 5.70.5Latest Dlink driversUsing XP's built in WPA supportWe have a radius server, 2003, use WPA-TKIP.I can't get these cards to see the access points a...

My company will soon start deploying 802.11b wireless into our 1700 branch locations. The stores are small and will only require 1 Ap for the most part. We have three concerns: 1)security 2)interference 3) managementDoes anybody here have a similar s...

Hi,To solve some roaming problems with ap1210's with Ios 12.2(15)XR2 in our distribution center, Cisco has advised us toupgrade to Ios 12.3(4)JA.We have done that but after 5 days, we got complaints with associations to the ap's.A reload solve the pr...

Our systems will be deployed in mountains where sufficient electricity power is not available, which requires small power consumption in the harsh environments. I have checked the specification for “CISCO AIRONET 1300 SERIES OUTDOOR ACCESS POINT/BRID...

I am going to set up a wLAN where there are 4 data collecting instruments (A, B, C, D shown in the plot) in a mountain. Two neighbor nodes are 10km line-of-sight distance away from each other as shown in the attached plot. Point D communicates with s...

Hi All,We've recently agreed to begin to deploy a WLAN infrastructure throught our network. My manager has suggested we use the Apple AirPort Extremes. I am wondering how those compare to the 1130AG. I am fairly new to wireless design. Has anyone eve...

I am trying to get a Linksys WET54GS5 bridge connected to an Aironet 1200 using PEAP. PEAP authentication to the Aironet 1200 works fine from a Windows XP wireless client setup to use PEAP. We are using Windows IAS for RADIUS authentication on the ba...

We have Mac users using IBooks to connect to our secured network. Previously, we didn't have security but we added WPA/TKIP and Peap supplicant. Will it still be possible to connect our Mac users? I've checked one user so far and they don't have Peap...

Configuration:- Access point 1200 series- IOS 12.3()- multiples vlan- vlan guest, without security, guest-modeFacts:Connection with HP and DELL Laptop work fine.Connection with IBM Laptop with software "IBM Access Connection" for multiple management ...

Anyone know how to set the config register or something similar to force a reset of the AP back to its defaults. I want the config to boot every time from our wireless lan solutions engine and this works by using the dhcp option on the ip address of ...

What is the default time out value for cached credentials using WDS and where can these values be modified and monitored?Thanks,Mark W. Anticola

Hi,I would like to know whether Aironet 350 series support IPv6?I know that an access point/bridge is a L1/L2 device, so it is independent of the uppper layer protocol.Therefore, it can support IPv4 and IPv6. Am I right?Thank you.Regards,Delon

Hi,When using AP1100's and 7920's does anyone haveany adise on the configuration of the AP thatdiffers from Cisco Recommondatin Papers.Considering if the AP and Phones are running the latest firmware. The reason why I ask is because we are finding th...

Hello Everyone,I'm curious if anyone here has installed any 1310 series bridges in outdoor harsh environments and how your antenna's held up. By harsh I mean very high level of vibration, dust, harsh winter weather etc. If anyone has any stories good...

Hi,We are experimenting with one 9 dB antenna on a Cisco 1200 access point.We first put the antenna on the antenna outlet marked Primary/right. We the then disabled diversity and configured the access point to use the right antenna. Then we got a ver...