Wireless

Hi all,i've very poor knowledge about wireless environement, but i would know if it is possible to have this scenario in point-to-multipoint configuration;1) 1200 device configured as root bridge and AP for clients2) some 1200 devices cofigured as NO...

Hi,I want to setup a wireless connection as follow, is there any problem?AP1200 <---> WMIC#1<--->WMIC#2<---> wireless userFor the role in radio network, AP1200 will be configured as Root AP, WMIC#1 is WorkGroupBridge and WMIC#2 is AP. So the setup is...

HiWe are using 2 BR350 with Omni antenna, they are about 2m space between the 2 antennas of the 2 Br350.They have different channels but the same signalstrengh from to the clientsthere are about 40 Clients (WGB350 - with leap) around the bridges but ...

Hello all,I am putting together a Wireless LAN solution for a client. Problem is I am using Cisco LEAP for authentication and I can not authenticate to the AP when it is being used as the Authenticator (local radius configuration). It works fine with...

Hi,I am thinking about CCVP and Wireless certification. Does Cisco provide formal certiciation training for wireless?Thanks.

Hello,I would like to know if it is possible to configure a WLAN to authenticate laptops using the computer ID that can be found in the active directory. The authentication is done with the help of an ACS 3.3 and Actice Directory.Thanks in advance fo...

Hi,I would like to know is there any third party antenna that can be attached to a Cisco AP 1200?Where can I find out more about it?Is Cisco recommend customer to use other types of antenna to connect to a Cisco access point? What is the impact the c...

Hi,i have an ACS 3.3.1, microsoft ca, ap 1231G and trying to perform Peap.This is the config:- wep applied to a specific vlan- wep key activated and mandatory- authentication open on ssid within that vlan- authentication network-eap on ssid within vl...

My AP mgt VLAN is set up so that I can't get access to an NTP server. I am wondering if the WLSE can be configured as a server.Thanks

Hi all,I've some Cisco 1100 APs, and I managed to turn one of the APs to detect rogue APs. I did this buy changing the MIB field, station role, to Rogue AP detection. The problem is that I think the AP is not detecting anything. I tried to turn on so...

Hi, When I do a show int dot11 command I don't see crc errors and others but using the web based tool I see a lot of crc errors, header crc etc.Has anybody faced this problem? I have already cleaned the log but it is increasing every minute. Thanks

Hi all,Probably a very simple question...Is it true that I only need to create a dot11radio interface for corresponding wireless VLANs and not management addresses.The reason i ask, on most access points i have seen and not configured myself, if for ...

What is the URL where I could find the MTBF of an AP 1231G ??