Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 17 , 2026 through Tuesday August 31, 2026. Our experts Saikat Nandy and Prashanth Bargur Hanumantharayappa will be waiting to assist you and resol...
Hi,I'm having a problem achieving good performance on a Cisco 1200 AP [802.11b] which supports about 15 clients. It's been configured to allow only 11MB & 5.5MB access with static WEP & w/o SSID broadcast. But somehow the performance is way below sat...
How many ip wireless phones support Access Point?
Hello group,I have wireless bridge 350 and omni antenna--AIR-ANT24120( 2.4 GHz,12 dBi Omni Mast Mt. Antenna w/RP-TNC Connector). I want to know:1. How many low loss cables do I need between bridge and antenna for each bridge?(one or two)2. How many l...
My ap1100 image was crashed by mistake.Crashed ap1100 is not bootable.There is no console port, so I have no idea how recover my ap1100 to factory settins.Please help me
Hello, Can anybody tell me that the Cisco Aironet 350 Series Access Points can support how many clients at one time?Thank you.
My company is about to go live with its first wireless extension of our internal LAN. Our original intention was to provide wireless access to our customers and vendors while they were waiting for appointments and/or attending meetings in our confere...
HI, If i have a AP 1100 or 1200 working with 802.11g, can i work with 802.11b clients ? Can someone please help me ??Best regards, Luis.
When doing testing yesterday in the a new floor in a building, I changed the channel of the AP from 1 to 11 due to the fact that there were a couple of other devices I was seeing on channel 1 with the AirMagnet software. I immediately noticed that my...
Can someone do a show version on a 3800 series router and tell me what the processor size says.Our 3640 is strained at the moment and if more mem won't alleviate the CPU usage. I think we may have to upgrade. The 7000 would probably be overkill.
Hi,about 802.1X protocol I've read " The authentication server may use the Remote Authentication Dial-In User Service (Radius server) although 802.1X does not specify it."Is it possible authenticate the supplier without using an external Radius Serve...
HI, I´m new to WLSE. My AP´s are already discovered and managed, but when I try to download the configuration archive from them, the Job Always fail with a SNMP timeout error message. This problem occur in the upgrade firmware job too.Whe I go to rep...
I found this in the WLSE 2.9 documentation:"Note Only routers and switches that have properly configured access points or bridges attached to them will be discovered"How does this help me when doing rouge suppression? If a user attached a rough AP to...
Is WPA supported on a aironet 350 AP ?I didn't found any information on the site in the datasheets.On the other hand, the support for WPA is mentioned in the datasheets for the aironet 1200 AP.Can I then assume that's not support on the AP 350 ?
Hi, Is it possible to change the date format used in WLSE to a more UK friendly format of DD/MM/YY rather that the US format of MM/DD/YY ?
If I use a 1200 with both A and G radios, can't I only hook one antenna up to each radio? If so doesn't this reduce the effectiveness of both radios due to multi-path interference and not being able to use 2 antennas for diversity?
