Wireless

I am running a Cisco 1200 Series AP. When I use the HTTP interface to configure a WEP key for 128-bit I can only enter in a 23 character long key. However if I telnet into the AP I can enter a 26 character key. Why is this and how do I change the HTT...

We have a reception area that wants to be completely wireless and they want to use headsets so they can walk around. Can we use a wireless headset with the 7920 phones?

Hi. I'm helping someone design a set of technology upgrades for a new apartment building. This building is still under construction, and when completed will have 71 luxury apartments spread over 46 floors. Each apartment has 10/100 ethernet jacks in ...

Per CiscoCisco Compatible client devices and Cisco Aironet 802.11a/b/g PCI and CardBus WLAN client adapters will support EAP-FAST in the fourth quarter of 2004. Anyone have an idea when this will be supported?

Is is possible to configure ckip (the prop. version from cisco for tkip) without external radius server?If yes, how?any input is very welcomeOliver

I was wondering if anyone would be able to help me out and guide me in going around configuring a Local Radius Server on a Cisco 1210 AP with the latest code and with WLSE running the latest code (2.9) so that I can scan for rogue access points with ...

The AP I've set up for WDS is not authenticating to the WLSE even though it sees it and has it registered as a WDS device. Can someone walk me through the configuration for both the AP and WDS so I can get radio monitoring to work?

Whats the best way to setup a guest side on a WLAN? I already looked at the SAFE blueprint. We currently have a 1300 with two cisco 12 dbi Omnidirectional antennas. We are covering an area about 1/4 mile, plenty to cover one of our campus locations w...

HiI have the following situationACS on windows 2003 ad domaincontroller and 2003 CA Service. the problem i face is that when i want to make a server certificate for the acs i need to make a Webserver ca over localhost/certsrv like on this document: h...

Hello,When I was making a software upgrade on a ap 1121, the ap went out of power (reload) and after that the ap never came up, is there any boot recovery procedure for seeing the contents of flash or there is any other way to upload the ios to the a...

Hi,I have 2 sites with Voice-enabled routers installed. They are connected to PBX in both sites.These sites are connected to each other via a 2.4Ghz 802.11b wireless connection using Aironet 350 bridges.The link is currently used to carry voice only ...

I have two aironet 350 bridges with yagi antennas connected to each other. the link is very good and there is no problem in data transfer. but when I generate voip traffic the latency between the two bridges goes up to 700-1000 ms and the packet loss...

I've installed AP1200 running IOS 12.2.13ja & 802.11g.My notebooks are IBM/T40 with wireless card running 802.11b.If I configure an AP at 11Mbps, can I use my notebooks running diferent protocol than AP ?.Thanks in advance.

According to Cisco site the ETSI configuration will only broadcast 45 meters. Is there a model which will allow us to broadcast 260 Meters at 54Mbps?

Hi,I am using Aironet Wireless Client Adopter running on Win XP and Win2K machine. The WLAN Clients are connecting to Cisco 1200 APs which uses Radius (ACS 3.2) Authentication through MicroSoft Active Directory user Database(installed on Win2K Advanc...