Wireless

sir,i am looking for a software which can integre theses function:-site searching-frequency planning-interferency claculation-easy import of standard fileWe appreciate any software.

I recently purchased the Linksys wireless ADSL gateway.I have an IBM T40 laptop (Win 2000) with built-in Aironet wireless (ACU v6.00.023)I have successfully connected several PC's through Ethernet connections but cannot get the wireless capability to...

Hi,I need to understand Cisco's interpretation of OPEN Authentication. Cisco documentation reports Open Auth as "allowing any device to authenticate with the access point but the device can only communicate if the WEP keys match the Access Point's. C...

I have a LEAP environment with CKIP enabled. MY LEAP timers are set to 4 hours, but I consistently get these resassociation messages on my IOS AP's: %DOT11-6-ASSOC: Interface Dot11Radio0, Station 0007.0eb9.ad73 Reassociated KEY_MGMT[NONE]For the most...

As far as I know 802.11 specifies the PHY flavours, DSSS, FHSS and IR.I want to deploy an 802.11b/g solution but there is a 802.11 FHSS cells for inventory applications. I think that 802.11b is not compatible with 802.11 FHSS, only DSSS. My question ...

I have an office with 3 PCs which I want to connect using a wireless network. I was thinking of using the Aironet 1100 and 350 series wireless cards. I have an additional room about 30 metres away (housing a signal PC), separated by a couple of walls...

Hi, anybody know of any good self study materials for the 642-582 WLANFE exam? I'm CCNP and have considered the following book.802.11 Wireless LAN Fundamentals By Pejman Roshan, Jonathan Leary. Published by Cisco Press. ISBN: 1587050773Is this enough...

I am runnign 1200's with c1200-k9w7-tar.122-15.JA I have the loccl Radius server working but when I change it to EAP with MAC I cannot get auth. I am setting up in advanced security to go to the server and have the server IP set up for the MAC and EA...

I've the very same MAC-addr.on both BVI and 802.11g Radio, how do I change it?And also, when hit the command "sh int" there are a line after the print-line MAC-addr.saying;(bia 0011.926e.09b0) what is that saying?

Upon looking in Network Config area of 7920, all I see is Site Survey & Mac Address. What could be the cause of the other options missing?

Hello – Perhaps someone can help with this issue – I have 3 1200 APs – One of them supports G clients and G clients connect OK – however I can not get 802.11b clients connected. – My config is basically the same on all 3 access points – Any thoughts?...

I hope future release can address the following shortcomings:1. Better Correlation Analysis for detecting rogue or unknown AP. Currently it triggers alarm for all range of RF signal strength. So an AP well outside the office will trigger a false posi...

Everytime I try to upgrade to this I recieve an error approx. 2 min into the upgrade:Error: The software upgrade was interupted and was not able to be completed.My current version of OS is IOS version 13.JA. I have never had a problem with upgrading ...

Signal Strenth is defined as signal power at anthenna mesured since syncronization till the end of the PLCP header.Signal Quality is a correlation quality mesured during the same period of time.SNR can be counted using Signal Strength(in dBm) and Noi...

Could the 1310 do "Protocol Filtering" for TCP/UDP?