Wireless

When connecting a Catalyst switch to an AP 1100/1200 ethernet port, what type of ethernet cable can I use - a straight-thru cable and/or a x-over cable? In the Cisco docs for describing how to connect locally to the AP ethernet port via a laptop, it ...

Hello,I have one wlan with lots of Cisco AP1121G (IOS 12.2(15)JA). The wireless clients authentication in based in Radius Server (Radiator) using 802.1x with EAP-TTLS.For infraestructure management i have the WLSE Appliance (WLSE-2.7u firmware).To ta...

Hi everyone,I have some Intel clients running on a Cisco 1200 backbone that would roam only after loosing the connection with the current AP. I know the Intel driver is not flawless but what can I do to get the best from my AP's at least? That in ter...

Good Day,I am looking to assist a local elementary school provide wireless access to their wired lan from their new portable classrooms. As it is a school their equipment budget is low and my time is on a volunteer basis. The portables are going to b...

Hi,I am trying to setup two VLANs from the Aironet 1100 AP to the Baystack 420 switch. One VLAN will take domains users and the other will take guests. Authentication is taking place with a Radius server and everything works great until I configure t...

HiSorry, me again.This may appear like a strange question, but has anyone experienced problems with the new Cisco tri-mode cards getting an IP address via DHCP after successful authentication? The reason that I ask is that our client has recently pur...

I have a second WLAN implmentation underway. We have 5 APs and a Cisco 3550 switch. I have deleted all the default vlans / ssids from the IOS AP1200 ver 12.2 and then created two new ones:SSID GUEST associated to VLAN 10 NativeSSID Engineer associate...

I am designing a wireless solution for a client and am looking for some valuable insite that this list might provide. The clients data infrastructure is all Cisco. Mostly 3500 series switches and 2600/3600 routers. I am looking at the 1200 series AP'...

Does anybody have access-list logging working on an 1100 ? (12.2.15-JA)

Hi AllTo try to solve a roaming issue, I have upgraded a client's APs fro mVxWorks to IOS. Basically, previously with the VxWorks APs we had a single SSID and had 2 VLANs associated to it. Assignment to each VLAN was controlled on a per-user basis by...

I'm proposing a Cisco WLAN solution using 1200s AP. What is the best security appliance to use, ACS or WLSE ? Competing product is the Nortel 2250 Security Switch. Thank youDJE

For us to get started with a Wi-Fi training room I'm looking for a general recommendation on what equipment we need. We would likely install this in our 3rd floor training room. The training room could have up to 20 machines connected to the network....

I want to configure my access point as follows:- the wired interface should have a static ip and is directly connected to the internet - on the wireless side the access point should work as a dhcp server and assign private IP's to the Clients- the ac...