Wireless

Has anyone else configured handheld devices to use your wireless network using PEAP, but no certificates? Instead authenticating with username/password/domain.All of Microsoft's documents say they support PEAP but none say how to configure it.

I am running 12.04 (non IOS OS) and can not find where I would enable or setup WPA. Am I just overlooking this or do I need to install the Cisco IOS on the AP in order to take advantage of WPA?Thanks!

Periodically, I lose the ability to browse to any and all of my 340 and 350 AP's. They still work and pass traffic, but I can't get to them. I can ping them, they ping ok, just can't browse. Any idea why?

I've configured my AP wireless device to authenticate using LEAP via Cisco ACS 3.x. everything works fine as long as the NT user ID is associated with a password. However I do have a generic user ID that is used by a quite a few employees and it does...

Which solutions can i have if i implement in my branchs officces an Aironet Wireless Lan and i want to use the CSACS for the authentication proccess.The fact is that i dont't want to depent on the Wan link for the authenticacion Proccess, if the CSAC...

We have 2 sites that are under 1000' apart with clear line of sight. I would like to bridge the 2 LAN's together. In the past I would have used a 350AP and a 350BR... can anyone recommend what AP/Bridges I should use today for this config?Thanks

We have a Aironet 1200 unit with the upgrade radio for 802.11a/b/g. When using 802.11a/b/g PCMCIA cardbus adapters, including the Cisco CB21AG, we experience problems with applications software crashing at random. Examples of software are Microsoft O...

I'm still in the process of familiarizing myself with Cisco wireless products (HW and SW) so please bear with me.Is the Cisco ACAT required for all Wireless installations? Or is this an optional tool for management?Thanks in advance.Ariel

I'm evaluating both Cisco and Foundry Wireless Access Points for 4 large buildings in a campus...probably about 240 access points total. The installed LAN unfortanetly is Foundry on the Edge and Marconi ATM in the core...and it's not changing any tim...

I am looking to set up a AP1100 access point and want to use the Radius authentication package that is part of Windows, does the AP authentcation package work with it?

Does anybody know any good debug commands to monitor traffic/performance on an AP? A group in my department just purchased a few wireless cameras and we want to see how the addition of these cameras will affect the overall performance on wireless.Tha...

Hi,I would like to attach a pair of 12 dBi high omni antenna to an access point for indoor coverage. Has anyone has done the similar design? I would like to use the most powerful antenna to cover 20th floors. My customer can only afford to purchase 2...

I have several accecc points 1220 connecting to thesame 3550 switch. I am able to connect fine the signal is good, however my phones give a clicking noise when they receive or make calls. I was hoping if any one has any suggestions. Thanks Dennis

I have an AP1210 IOS 12.2(15)JA. I had everything working in my lab. Now it's at a remote site and I receive the following log message even though I have an SSID configured under the dot11radio0 interface.%DOT11-4-NO_SSID: Interface Dot11Radio0, no S...