Wireless

Hiwhy does the peap authentication also work if you dont push the root ca from the acs ca to an client.it seems that the peap authentication also works if you dont click on "validate server certificate" (under: http://www.cisco.com/en/US/products/sw/...

Hello,I have installed Win 2000 on the Axiomtek P1000-370 unit. It's motherboard is SBC8360. It has a PII 850 processor. This system boots fine without the client adapter installed but when installed in the PCI riser card the unit will not boot. It f...

I'm setting up MAC address authentication and need some way to bounce users off when they are blacklisted. Using SNMP, is there any way to force every wireless client to re-authenticate on an access-point?

Hi,I have observed that it is not possible to configure WPA-PSK in Cisco Aironet Client Utility for Cisco 350 series adapter.WPA-PSK is supported in Cisco Aironet Desktop Utility for Cisco AIR-CB21AG (802.11a/b/g card bus adapter).Is there any work a...

Hi,is there a way that a/b/g cardbus client will work on HP ipaq 5450?There is no driver on cisco software downloads exept for XP and W2000.tnx, bye F.

I am running 12.04 (non IOS OS) and can not find where I would enable or setup WPA. Am I just overlooking this or do I need to install the Cisco IOS on the AP in order to take advantage of WPA?Thanks!

Folks, If i have 1100 and 1200 series cisco access points at my location with G radios in them. How does the fall back work when B cards try to access these access points. Do the # of channels reduce, and what about the overlapping channels? are thei...

Folks, I have installed about 10 access-points in a company. Everything seems to be working fine, except fast roaming. I had a question about overlapping channels. Since the access-points have G radios, i presume that you can have 8 overlapping chann...

Is there configuration example on CCO for EAP-FAST(for ACS, Client and AP)

I am hoping someone can provide information or suggestions for how to migrate 1800+ 350 APs running VxWorks to IOS.There has got to be something other than the conversion tool, one at a time method.Any help is greatly appreciated.

Hello,I'd like to know if, when we set up multiple SSIDs (a, b, c, d, etc....), users from SSID "a" can see users from SSID "b" on the WLAN, etc...Thanks,Eric

I am trying to setup PEAP for our WLAN. I have a Win2k server SP4 and ACS 3.2(1). In the EAP configuration >> PEAP >> I select "Allow EAP-MSChapv2 and EAP-GTC" and "Allow MS-Chap Version 1 Authentication and MS-CHAP Version 2" >> I hit submit and I r...

I am trying to set up multiple VLANs on my 1230g APs. I have successfully configured the AP so that depending on the ssid I use I associate to one VLAN or the other (ssid test to VLAN 10 and ssid test1 to VLAN 20). The problem is I only get network c...

I have both the Linksys WET54G and WUSB54G. Both can connect no problem to the Aironet 1200 w/o WEP.Enable WEP, and neither will work. Am I wasting my time trying to get it to work? If so, what is the best alternative for a Wireless 802.11g workgroup...

Hi everyone,I have a issue when I try to connect a application in my network environment.We have some stations with wireless connection (802.11g), clients in a 1100 Access Points, and only these stations try to connect in a application, thats runs ba...