Good morning,I hope everyone is doing well. I have a noob question. We have the MX400 and I was curious to see how to pinpoint who is the bandwidth hog in real time. Example....I see that there are huge uploads going on through Appliance Setting/Upli...
Dear all:I'm attempting to solve this issue, but I'm having trouble.The customer has this error, which is the problem.Page in blank and the error ssl_IDMISMATCH
As shown below, what may cause the following channel changes？ can't understand the meaning of "Signal Strength"low SNR? or othersChannel changes will cause users to briefly disconnect from the network, I want to reduce the impact
Hi, I can't get http/https/ssh sessions to standby WLC 3504 when primary is off, version 8.10.185, all clients communications work well... The WLC respond to pings Is it normal or is there any configuration to solve this? Thank you Cheers
I have a simple setup of WLC 2504 v8.3.150.0 + 1142 + 2702 + RVS 4000 router with no VLAN. My requirement is to setup these two APs in FlexConnect mode. I have provided the snapshots of settings for the SSID. I have created a separate AP group for th...
Hi Folks,I need to configure an SSID which will be anchored to a foreign controller. The foreign controller is NOT on DNA Center. The C9800 is managed by DNAC however it seems the configuration to do this all on DNAC is post the software I am on and ...
We have WLC 5500 and we need to create URL filter in ACL but We couldn't find URL ACLs under access control list to do so. If you have a solution to help us please show me how?
What is the IPv version for AIR-AP2802I-x-K9 WAP device
Hello team,I have two sites, both have WLC CT5760. Each site directly connects to the internet and also has a MPLS link.Each WLC has the same SSID name for both sites, VLAN ID also same, however the subnets for each of these are different.Site A - St...
While changing wireless license level from Advantage to Essential, port-channel got disabled automatically and as wireless management vlan was down no AP was joining. So, need to know whether there is any dependency on license level or not?
I have Cisco Catalyst 9800-CL Wireless Controller and Five 1702I APs that are connected and have DNA Essentials licenses.Clients have been unable to authenticate. Have DHCP setup and have confirmed that clients are get IP address on the network. Sugg...
Hey there,We are running a large campus with public and trying not to have have overly large subnets. I can set subnets per geographic area but when walking from one area to the other the roaming is not working the way that I'd expect...We are runn...
Hell Hope everyone is doing well! We have setup a nps server and have it integrated with Meraki wireless for a specific SSID. We have gotten a cert from GoDaddy have it imported into the NPs works fine there. we are using user authentication to conne...
Hi guys! Does any have found how to change channel width for 6GHz to ohter than "Best(DBS)"? 20MHz, 40MHz, 80MHz and 160MHz options are disabled when I created a new 6GHz rf-profile. Only con modify max width in "Configuration > Radio Configurations ...
Hello, to deploy SSID tunneling, how do you size the MX at the central site? depending on the number of SSIDs per terminal per site, if, for example, we have 100 sites and 2 WIFI terminals on each site, I need an MX that supports 200 tunnels?do I hav...
