Wireless

Is it possible for a WGB in Version 8.84 to act as a LEAP client (supplicant) instead of the connected client NICs in the workgroup?This question is as important as the workgroup could be composed of IP Cameras or other IP devices who could not act a...

We have two buildings that are currently connected via a frac-T1. Most of the traffic is data but 2 channels are voice. We want to eliminate the T1 and replace it with a wireless solution. A site survey has been done and we should be ok. The distance...

I have Cisco ACS working as my AAA server for Wireless users login using EAP authentication associted with an SSID . I have configured another SSID with new VLAN ID , configuring everything right on the Radio interface and the Fastethernet and config...

Is it possible to create a virtual interface in Cisco's Aironet device for the management purpose. For example, I like to create following vlans:Vlan 2 for ManagmentVlan 3 for data Vlan 4 for voiceWith the basic layer 2 concept, for example, Cisco 29...

Hello All,presently I am using Cisco AP Aironet 1100. 802.11allows the clients to probe for a network. Is thereany possibility with Cisco AP to answer to the proberequest? Is there any possibility to send a differentSSID for probe response?Thank you ...

Hi,I have a network with some AP1100 with 12.2(11)JA, in the document "Wireless IPT Design Guide for the Cisco 7920 IP Phone" I can read:"The Cisco 7920 IP Phones support a QoS similar to EDCF for upstream (toward the AP) traffic. In additional, the ...

Hi Everybody,Is it possible to manage IETF Radius Attributes for a user or a user group in a Windows Active Directory Database in the case of an installation of Cisco Secure ACS v3.2 with an externally user database (Active Directory).My Idea is to m...

We have a large number of Aironet 1100 Ap's installed using a radius server & backup server for LEAP authentication. We thought everything works fine until yesterday the primary radius server died. We were no longer able to connect the wireless lan. ...

I've already gone through trying one (low priced) card that would not sync up with my Linksys WRT56G AccessPoint/Router and I figure it's time to do it right, get a Cisco PCMCIA card. However, I have read a review from a web site were a person was un...

We have an all Ethernet over wireless 802.11A (designed as Point to Point - not running PPPoE)spanning many sitesthe post concerns only 2 of the sitessite #1 has a 10Mpbs router (2621) and site #2 has a 10/100 router (2621XM) so that WAN is scaled do...

On our Hotspots we are sharing the access points by crating different VLANs. Both companies want to manage (SNMP the APs using WLSE from different networks. It is only possible to define one default gateway on the APs. Is there another way to manage ...

Is there a way to display the spanning tree status of the ports on a BR350?

Hello,I am looking for someone who could help me i have a short time to configure an AP 1100 with security parameters and i am a dummy in this subject.My customer require leap authentification and tkip encryption. He wants the ap to act as a local ra...

I have a question that someone can probably answer pretty easily. My wireless users are very picky. They don't want to see multiple SSIDs. Especially when you have a dual band AP. So, I would like to have the same SSID for each antenna (a and b) on t...

I am looking to implement a point to multipoint wireless bridge network. Security is of high importance and I am looking at ways of providing security to 802.11b. Is IPSec the way forward or should I be looking at 802.1x LEAP as a viable alternative....