Wireless

We are using Cisco 1200 AP's(802.11b). If I had an area where there is channel overlap, how would I know that it does exits? Is there certain errors to look at on the AP's? I don't see anything in the log to reflect that it could be occuring.

I have all my wired network devices on vlan 1. I'm almost out of addresses on this subnet. So I would like to put my APs in a different vlan using a different address range. If I make the vlan my AP are in native can they still talk to wired devices ...

Is ther a way to improve strong security between two wireless bridges 1400 without use of a RADIUS server?Thanks,Ronaldo.

I have 2 aironet 1100, one of which is associated with the other as a standby. The standby disassociates itself from the active access point when the wait for poll timer elapses, this also takes the radio down. This seems to be from a virtual interfa...

I want to configure the WEP or other security mode on thin clients - they can't operate on graphical mode.I've tried the Cisco tools all works fine but on X environment - I can't configure or start the WEP without X. I've tried "standard" linux tools...

dear all who can tell me the polarization of cisco antenna ,when I see the training book gived by cisco,it is vertical,but in fact it is vertical and horizontal,who can tell me the right answer? thanks a lot

Hi, i'm looking for a device to point Dish antennas.We need an HW that help us to see if antennas are correct pointed, like a signal generator but at very low-low cost. Does anyone can help us in this research ?Thanks

I just recieved my 1400 bridges, and was surprised when they had a dual coax feed from the power injector. I was lead to believe that it would take a cat5 cable. It shipped with both a 20' and a 50' cable that you can connect with a grouding coupler....

I'm having a hard time understanding what WDS is and whether I should enable it or not. I've read the documentation, but I don't understand if this is just for Cisco devices (clients and APs). I think I need it if I want to take advantage of rouge AP...

I've installed the latest and greatest WLSE 2.5 and am starting to upgrade our 340 AP's to 1210's running 12.2(13)JA.350 Series Clients running ACU 6.2 are associated and key management is CCKM allowing Fast Roaming. The "Enable Radio Management Supp...

I have 1 Root Bridge 350 connecting to 3 non-root bridge 350s - all within 500 feet. Connections hang and I can wake up sometimes by tracert. All units have the same problem. They have all been configured with quick setup. Take 340s - also configured...

I have a WGB352 associated to a BR350 in AP mode. The problem is, when I am looking at the association table on the BR350, it says the WGB is a repeater and its parent is [self]. How can I fix this so it will work as the client?

Can a 7920 be used with a 802.11g only Access-Point ?

We have Cisco 1200 AP's, laptops with 340/350 NICs work fine. Compaq tablets W/Intel wireless and iPaqs cannot obtain IP Addresses using DHCP. These devices associate, the AP 'sees' the MAC address but does not pass an IP address. Tried changing radi...

Hi,anybody knows a 802.11b USB (!) adapter which support PEAP authentication?RegardsAlex