Wireless

Hello,Does anyone know where I can find some guidelines for a site survey.regdsJohnny

Hello,I need to repeat a signal between a big wall.AP1-< ~ >-AP2-< ~ >-WGB1AP1 is rootAP2 is repeaterI know that using a splitter is not recommended in AP2. So on AP2 can I use an directionnal antenna directly attached to Right connector and a second...

I've just bought a 2nd user AP-350 but can't reset it. I have found its IP address using CDP from a connected switch. When i browse or telnet to it i'm prompted for a username & password. This is the same for any console access.I have followed instru...

We have a 1200AP with both 802.11b and 802.11a antennas. Now, the documentation for the 802.11a antenna (flip-top antenna on AP) says it may be a omni-directional or patch antenna functions.Does it perform both? If not, how do I switch from omni to p...

Got two new AP 1200s. came with the VxWorks OS in it.Wanted to upgrade the image to IOS 12.2 JA.Downloaded the VXWORKS-to-IOS conversion image, and started upgrading the AP, via the web browser. In between the upgrade, due to a power outage, both APs...

I have an AP350 shooting a link to a WGB350. The link is about 150m wide. On the WGB side there is a hub with one IBM Netstation connected. They have been stating that everytime they need to use the netstation they have to reboot it, to get it to con...

Hello,I have a Cisco 350 Wireless bridges setup 18km apart.One is setup as Root and the other as NON-Root.If I connect one machine, its works fine.As soon as I connect more than one machine I loose connection to the server on the headoffice side.I ha...

Hi,I have 5 cisco 1200 APs each about 1 mile apart at each tower. Clients have Yagi's on homes pointing to the closest tower having disconnect issues. I have heard that we should not have any AP's within coverage area using overlapping channels. That...

How do you configure WPA security on a 1220b access point running IOS software? Does anyone have a sample configuration to go by?

Does anyone know about Antenna Splitter for 2.4 Gh I would like to try an AP with 4 Antenna ?? Does anyone know the product number of it?? so I can order [email protected]

Each of my 80 Aironet 350 AP's (all with 12.02T1 firmware) drops all its clients about one to ten times a day with this log message for each client:Disassociating [al]00022d1b5416, reason "Sender is Leaving (has left) BSS"Within a few seconds that's ...

Has anyone found a wireless sniffer that works with 802.11g?

I have 4 350 series access points, 3 repeaters and 1 root access point. All is working well with the added security, BUTafter around 19 days 2 of the repeaters tell me that they are leaving the "BSS", then i cannot log on the them and when i try with...

Hello,I have a 10 nodes wired LAN about 100meters away from my wireless LAN and I wish to access the Internet through the wireless. Can I connect the wired LAN through an AP or must I use a bridge or workgroup bridge?Thank you.Chafe

Does anybody have experience with this security standard? We have a combination of mobile vehicles and fixed sites on a test grid. All are using either BR350's or WGB350's. We have 3 towers with one tower accessing the post LAN. All towers are using ...