Wireless

We bought a large batch of 1200 APs (1220b) soon after they were released in North America. Since the past winter, we have been hearing that IOS was coming to the APs as an upgrade. Now that it is here, we come to find out that IOS will only be suppo...

HelloI have spent the past 30 minutes simply trying to obtain the system serial number for my 350 wireless bridges and access point. I scanned all that was in the management browser interface and could not find where I could get the serial number fro...

I've set up many, many 350 cards in Windows (alll versions). Having an impossible time in Linux, two different laptops doing Redhat 8.0. Natively, Redhat won't do much with the card, though it is listed in the wireless cards "supported" under Network...

Hi, This is the deployment architecture that I had : WLSE (Internet public add)--->xDSL----->NAT router---->BBSM--->APs I had a problem in managing the APs which the ip address will be translated to a public ip addresses. When I use discovery options...

Does anyone know of any good documents outlining what needs to be done in order to config a 350 AP to support 2 VLANs...1 VLAN using NetworkEAP with Broadcast WEP Rotation, and 1 VLAN with Open Authentication. I've been trying to get this to work and...

The default driver for Aironet PCI wireless client adapter does not support RF monitoring mode, but I want to have that feature. So, I am trying to write a driver for that card. Can anyone help me with the hardware specification and driver programmer...

Hi, I apologize if I posted this on the wrong forum but I'd like to learn the purpose, basics, usage, or any useful information about 802.1X. I'm looking for good links to start with. Thanks in advance for any help.

I have an open TAC case but was wondering if anybody else was seeing this problem. I have 150+ Cisco access-points being managed by WLSE 1.3.1. It’s a mix of 340, 350 & 1200 type hardware and running 12.00 code.First it takes between a hour to two ho...

Hi,I have a 1200 AP with 5GHz module and AIR-CB0a client adapter in demo.This all works fine (except coverage is not that good). But what I see is that when I walk arround and enter a zone with only 802.11b AP I loose my connection! So the card does ...

I am looking at implementing a WLAN across a campus on a 4-class C VLAN with an initial load of approximately 500 users to a maximum of 800 using AP 1200s. Does anyone know of the broadcast traffic that occurs? The only broadcasts that I can think of...

Only way to get wireless devices to see the default gateway is to enable BOOTP/DHCP. If access point is set to static IP then wireless devices can see rest of LAN except for default gateway. What is not configured correctly?

I would appreciate help configuring a WLAN using 3 340AP's:I intend to use one 340AP as the Root/Access Point.I have not been able to successfully configure the two remaing 340's as CLIENTS. I have association with the client 340's, and using a cross...

Only way to get wireless devices to see the default gateway is to enable BOOTP/DHCP. If access point is set to static IP then wireless devices can see rest of LAN except for default gateway. What is not configured correctly?

Hello Guys,i configure Portocol filter like on this Page , but still get a connection to my AP when i connect as a user,please helphttp://www.cisco.com/en/US/products/hw/wireless/ps430/products_configuration_guide_chapter09186a00800e02cf.html#1028373...