Wireless

Could anyone suggest the best way to avoid the interference to the wireless network from an outside wireless network. When a sniffer was connected these networks were found to be operating under different channels but we could see interference from t...

We've been noticing lateley that the forwarding state on the internal and external radios is 'Blocking' on some access points and 'Forwarding' on others. All of the access points are basically configured the same with the same code (12.03T) on them (...

We are working to install 3 floors worth of wireless in our office building, Which AP's would be the recomended ones? From what I take, the only differance between the three is upgradability. Is this correct?Thanks

I am not too familiar with Cisco's CLI. Does any body know of a good website\manual that gives the basic of how to use the CLI and the commands?Thanks

Can anyone recommend a good omnidirectional antenna to use with the Cisco Aironet 1200 Series AP?

We have recently been infected with the w32/lovegate virus. It appears that we have gotten rid of the virus, however since it has come along we have had our users getting kicked off the network 4 or more times per day. It is only happening to users t...

hello membersi have a specific question, can i use the AIR-AP1230B series access point OUTDOORS awaiting your repliesthanks in advancekalyan

AP 350 (fw v.11.21) Constant rebooting. The process doesn't quite complete, restarting after the loopback is set, returning right to the Testing DRAM ...<example>Attaching network interface lo0... done. Configured device "lo0" as IP address "127.0.0....

Background:We are implementing a multi-access point wireless infrastructure using the 1200 Series APs. We are presently using (1) 802.11b radio per AP. The clients are using Linksys PCI cards that support the 802.11g standard. For "security" we are u...

Can anyone help with this error? I get it for one AP 350 Root Access Point out of five. It happens ocassionally when a mobile 350 Workgroup comes within range and goes past.cheersRay

Hello,my application is a 350 Work Group Bridge in each of the two locomotives of a underground mine train. One locomotive is at the back of the train pushing and the other at the front pulling. The Work Group Bridges communicate with 350 Access Poin...

I am running VXWorks 12.03T on my 1200 series AP's. I want to upgrade them to IOS but the tool does not work for this version. How would I go about this upgrade.thanks