Wireless

Whilst running WinXP with a 350 PCMCIA attached, I inadvertently installed Microsoft Upgrade 815485 (WPA Update) and have since been unable to Associate albeit for 5 seconds following card insertion. Roll-back recovery proved that the MS upgrade caus...

HelloTwo monts ago we installed two BR3500 succesfully. One as a root and the other one as a non-root BR, there are parox 400 metters between each BR and no fhysical interference. But since last week the end users in the wired Lan in the non-root BR ...

I am currently using spectralink WLAN phone with Cisco AP1200/350,I found audio would be dropped. It is caused by spectralink phone would re-authenticate/re-associate AP many times in a short period time, Every timeit would casued audio dropped.Any o...

HellloWe are using LEAP with CSACS internal user database to authenticate our wireless users. We are using the latest ACU from Cisco and for some reason when we start the LEAP auth process, it takes up to 3 minutes on the finding domain controller po...

Helllo We are using LEAP authentication with CSACS internal user database to authenticate our wireless users. We are using the latest ACU from Cisco and for some reason when we start the LEAP auth process, it takes up to 3 minutes on the finding doma...

I have two buildings that are ~1 mile apart that I was looking to connect via Aironet 350 bridges but these two buildings are seperated by a natural hill so there is not line of sight. I can stand at the top of the hill and have line of sight to both...

So, we are about to embark on building a wireless network infrastructure using 1220 AP's. So far all wireless clients use Cisco cards and Win2k.People are interested in all sorts of wireless devices now, some including built in wireless nics or no pc...

Can you use 350 client cards to authenticate through a aironet 1200 and then to a ACS v2.6 server?

I have several outdoor sites with multiple BR350's in the same cabinet. In a drive to clean everything up, I am moving to rack mounting everything in Purcell NEMA cabinets. I plan on removing all of the the 'wall-wart' power supplies and replacing th...

Hi , I am not able to access the management console of BR-350 through IE- 6.0 using the IP address of the bridge in win2000 client workstation.I am facing the same problem in windows XP as well.However I am able to ping the bridge from both.But I got...

What other wireless nic cards can I use to connect to the wap?

when SYSLOG dispaly syslog message from catalyst devices , It always display the wrong time. say : the display result is always diffent from that in the syslog.log flat file ¡£ but it is ok on routers I finally compare the catalyst syslog message for...

I am having trouble getting the wlse to auto-discover an ap1100. I have followed the steps(at least think I have)necessary to get a ap that runs VxWorks to be discoverd1. CDP enabled2. SNMP RO and RW , that is also in the discovery credentials on the...

I have a WLAN with Aironet350 clients and want to establish an IPSec VPN tunnel to secure the radio communications between the wireless clients and the internal LAN. Could I connect all as follows and have the wireless clients be able to access the r...

Hi all,I have problem, I have cisco bridge 350 series, for the first time all working properly, but when i try to restricted the channel 11 than the probelm accur, all wireless client cannot associate, and the bridge still using channel 1 .But when I...