Wireless

AP 1200 doesnot boot up. When I tried to boot it up, it gives the following error: "The system unable to boot automatically because there are no bootable files to boot." Than it displays the software version of the AP and Cisco contact info. After di...

Can you use the Aironet 1200 box with 352 client cards and succesfully authenticate to an ACS v2.6 server?

I have a user that is running windows me. I installed a 350 series wireless PCI NIC and it will connected and then disconnect for the AP. I have changed out the NIC, changed PCI slots, updated drives, ACU and firmware on the NIC, but nothing helps. I...

Hello,I have a laptop with WinXP and Linux installed, last week, I update the drivers for the Cisco Aironet 350 cards from MS windows-update.Now everytime I use a card on WinXP then it never works again under Linux.Windows Aironet driver version is 8...

Whilst running WinXP with a 350 PCMCIA attached, I inadvertently installed Microsoft Upgrade 815485 (WPA Update) and have since been unable to Associate albeit for 5 seconds following card insertion. Roll-back recovery proved that the MS upgrade caus...

HelloTwo monts ago we installed two BR3500 succesfully. One as a root and the other one as a non-root BR, there are parox 400 metters between each BR and no fhysical interference. But since last week the end users in the wired Lan in the non-root BR ...

I am currently using spectralink WLAN phone with Cisco AP1200/350,I found audio would be dropped. It is caused by spectralink phone would re-authenticate/re-associate AP many times in a short period time, Every timeit would casued audio dropped.Any o...

HellloWe are using LEAP with CSACS internal user database to authenticate our wireless users. We are using the latest ACU from Cisco and for some reason when we start the LEAP auth process, it takes up to 3 minutes on the finding domain controller po...

Helllo We are using LEAP authentication with CSACS internal user database to authenticate our wireless users. We are using the latest ACU from Cisco and for some reason when we start the LEAP auth process, it takes up to 3 minutes on the finding doma...

I have two buildings that are ~1 mile apart that I was looking to connect via Aironet 350 bridges but these two buildings are seperated by a natural hill so there is not line of sight. I can stand at the top of the hill and have line of sight to both...

So, we are about to embark on building a wireless network infrastructure using 1220 AP's. So far all wireless clients use Cisco cards and Win2k.People are interested in all sorts of wireless devices now, some including built in wireless nics or no pc...

Can you use 350 client cards to authenticate through a aironet 1200 and then to a ACS v2.6 server?

I have several outdoor sites with multiple BR350's in the same cabinet. In a drive to clean everything up, I am moving to rack mounting everything in Purcell NEMA cabinets. I plan on removing all of the the 'wall-wart' power supplies and replacing th...

Hi , I am not able to access the management console of BR-350 through IE- 6.0 using the IP address of the bridge in win2000 client workstation.I am facing the same problem in windows XP as well.However I am able to ping the bridge from both.But I got...

What other wireless nic cards can I use to connect to the wap?