Wireless

Hi guys,I have 2 type of wireless network card, Cisco 350 PCMCIA and a Orinoco card.I should authenticated to the RADIUS server.If I configure the AP (aironet 1100) with the "authentication open eap eap_methods" in my SSID, the authentication on Orin...

Is there a possibility to identify a WLAN user on the wired network?How can I make sure, that nobody places a rogue AP in the network and get access to the wired network or a employee puts in a WLAN card and allows anon-employee to access to the netw...

I wonder if anyone could assist me with my question. I have been researching the use of the two unlicensed spectrums in the UK. These are 2.4 and 5 GHz. Within the 5 GHz spectrum there are 3 bands, the lower two, (A,B) have been designated licence ex...

I have a 350 series AP with the following :Current Version of System Firmware: 11.07Current Version of Web Pages: 11.07Current Version of Radio Firmware: 4.25HI have some 350 series PCMCIA cards with firmware 4.25.30 installed on laptops running wind...

Hello,I have a point to point wireless setup, using two AP 340's. I have the root set to bridge only, and the other end set to client. Is this correct, or should both be set to bridge?Thanks for any and all help,Jeff

Hi,the german RegTP has released the 5 Ghz frequency band.Do anyone know when the AP1200 with 54Mpbs (ETSI) is avaiable in germany inclusive the pc-cards/pcmcia-cards? If already available what ist the product number? If not, when cisco plans to offe...

I have loaded a 350 Series Client card into a HP Vectra PC. I previously had Version 4.13 software loaded on the PC with the old firmward for the Wireless Card. I updated the software on the PC to Version 5.05 as well as the firmware on the card. The...

I have a client that insists on using the hp wp 110 wireless print server with our Cisco 1200 APs. We use the block PSPF setting for various reasons. I cannot make his print servers work unless I toggle the PSPF setting in the Associations Advanced s...

Is it possible to hide the SSID and Network Range from a client running a wireless sniffer with the adapter in monitor mode ?

Does the 1200 have any SNMP OID related to the DC volts it's receiving?We're running on a solar powered system, and need to be able to monitor (and trigger alerts) if the voltage gets too low.Been trying to find affordable voltage monitors that are S...

Even though encryption is enable on both the Root and Repeater AP's, we're still getting farily frequent error:Station [AP22]000785b3362a Associated with Encryption, then attempted to send an Unencrypted packet to [ap13]000ab7af3095 (length 92) a few...

I can track traffic on the ethernet port and the wireless port of the AP, and even the "repeater" port of the same AP (is that the link with our repeater I assume), how can we output for MRTG type use, how much each IP/MAC is using, via SNMP? When vi...

Though the right servers are setup, and accessible to all our clients, both the Root and Repeater AP's keep reporting they can't access the DNS servers:Repeatedly failed to connect to DNS Server. Temporarily DISABLING DNS lookups for 5 minutes. To im...

Hello!Does anyone know what is the maximum length of UTP cable between the 350 Series Wireless Bridge, AIR-BR350, and the power Ethernet adaptor.The adaptor receives 220V AC and transmits 48V DC through the UTP cable to the bridge, the question is wh...

The wireless diagrams with the antenna documentation is confusing. It left me with the following questions:1. If you were using an omni-directional antenna (say AIR-ANT5959, for example) and have the antenna facing down as if it were attached to the ...