Wireless

I tried to connect a laptop integrated 802.11 client with an AP1220, using static WEP key (40bit).The client succeed in obtaining an ip address from the dhcp server, and it can ping the AP and the hosts in the lan but, from the AP menu and from the l...

I'm doing some test with an Air 1200 and some 352 Pc card for one of our customers.With ACU ver. 4.25.23, I enabled LEAP authentication using the windows user name and password.Leap authentication is successful, while windows domain logon not.Not to ...

Looking to do a project where the clients will authenticate via MAC address only. Client machines are running a variety of wireless NIC's and the customer wishes to support come one, come all.Does anyone have any experience with configuring freeradiu...

The AP has a female connector for the com port, rather than male. The DB9 that came with the unit is not available. All our spare DB9 connectors are female. Anyone know if the pin outs for this com port are the same as the usual Cisco com ports? Than...

hello engineers ,i'm wondering if cisco manufacture wireless equipments in the scale of kilometers.for instance we have been offered a project in which there is some wireless links goes as high as 35km and minimum 2mbps.i want to make sure whether ci...

I am trying to connect a pc to our LAN, which is across the street from our main office. I have setup 1 Aironet 350 as a root access point and the other as a repeater, each has an antenna. I have radio activity between the 2 access points but cannot ...

hello engineers ,recenty i've been offered to make a wireless-base network .i'm wondering if i could do my job by using cisco wireless equipments;min link bandwidth is 2mbps and max distance goes upto 35 km ,point to point .your comments are mostly a...

I have two 350s, point to point with Yagis. ~1000 feet. Signal quality is 97-100%Every 15 minutes or so the link dies and it re-associates. (error states-lost authentication with Parent ) When I disable WEP everything works fine. Are there any known ...

Hi,there's one PCI card for 802.11b, but none for 802.11a.Anybody knows if CISCO is in the process of introducing the one?Or it waits till 802.11g is going to be approved in June-July 2003...?---Any PCI cards for 802.11a that CISCO recommends??Thank ...

I have 2 sites separated by a 5km sea. I want to connect a LAN on a ferry to only 1 site at a time (limited by ETSI-regulated power and hence range). Can I use an all-bridge design and have the 350 bridge on the ferry roam between the two sites? How ...

We are investigating a wireless solution for a mobile DR unit & I am wanting to know if a generator would interfere with wireless comunication. The generator would be in close proximity to the network and I was wondering if it might casue some proble...

Hi allWe have about 100 locations (1000 AP´s) connected over a FrameRelay WAN. Now we want implement LEAP. Question: We have 2 redundant ACS for Authentication in the headquarter. Is it a possible solution to take these ACS ??

What's the history behind the 802.11b channels allowed in Japan? I have read where the IEEE Std 802.11b-1999 standard said only channel 14 was allowed. I have also seen several documents; Cisco’s included, that all 14 channels are allowed. I understa...

I have a problem with 340AP while I use appletalk protocol. but it works fine when I use my Mac Laptops with TCP/IP connection. do I need to make any changes in the the AP configuration so that it allow the Appletalk protocol...if any one has an answ...