Wireless

Sorry about the first post...I just brought up the 350 Aironet and I am sitting about 2 feet away. My signal strength is Fair running about 30%. I walked about 20 feet away and I lost the signal. Can anyone tell me why this could happen? and How do I...

Is there some document available that catalogs and explains the various error messages that might be logged by the AP350?

I need create a cable of specific lenght to connect a Aironet Bridge 350 to a Yagi AntennaI need to know the specification of the cable to be use !!!

I have tried to start an X windows client using both the relfection and exceed x-windows packages over Cisco wirless networks in two different locations but without success. I think the packages start lby issuing a UDP broadcast message and this is n...

I'd like to configure my AP350 via SNMP. In particular I need to change the accepted authentication methods (open, shared or network eap). Does anyone know which are the MIBs to use? Thanks in advance for your time.

Anyone has AirFortress experience? It performs Layer-2 encryption with AES, and it sis FIPS complaint. The ARMY is using it.http://www.fortresstech.com/Thanks,Audie

I manage a large health care network with very strict security guidelines. We have dedicated FW's at all our exposure points to the Internet and Extranets. This provides an assurance that allows us not to filter any traffic inside our FW borders. We ...

Hi,In a point-to-multipoint bridge network (1 bridge as root the others as non-root) bandwidth is shared equally. Is there a way to let for instance one non-root bridge have 4 Mbps and the other non-root bridge 2 Mbps?Thanks,Joost Koopmans

hi,it will be nice if anyone clarify my doubts below.1. How many MAC address storage does Aironet 350 supports , in otherwords what is the maximum nodes it can support at one end ??2. What is maximum practical distance Aironet 350 support with extern...

Hello,We have an office aprox. 3 miles away connected via an AP 340 and WGB 340, with a wired lan on the WGB 340 end (no wireless clients connected). Recently we added several PC's to the remote office, and discovered the 8 client limit. Is there any...

I have an Aironet 350 access point and also a workgroup bridge. I can ping & communicate with the workgroup bridge's ip address for setup & diagnostics from the bridge's ethernet side, but I cannot see it from the wireless side, i.e., through the AP!...

I'm trying to find a way to automate the configuration of large quantities of APs.I've written a script to do most everything, bu tthe user manager settings and WEP settings still elude me.Does anyone know the syntax of the configuration file for the...

Hi,I need to setup a wireless link to a new building that has no wired LAN. Therefore, I assume that I need two bridges? Can the bridge in the new building also act as an AP for 24 wireless clients, or do I need another AP to serve the wireless clien...

Is there any information, when PEAP feature will be supported in CAR.

Is there a driver or firmware download that will give me 64 bit WEP encryption for the Aironet 350 pcmcia card? If so, can you tell me which one?