Wireless

Hi all,We have 1 workgroup bridge which is not comunicating with any of other 2 Wireless bridges.Wireless bridges cominicate with each other and also with other vendor devices.ESSID is same of both.It shows no wireless activity at all.I upgraded firm...

What can be expected if using wireless trough half-foot reienforced concrete. How about aluminum/steel framed walls? I know I should get a site servey to anwser that (and will) but by experiance what would you say?ThanxJC

Just wondering by purchasing the Cisco AIR-ANT2506 Omni-Directional Mast Mount antenna does this send and receive?Basically I want to hook up the antenna to my wireless router and put the Antenna outside my house to extend the range and so I can acce...

Is it possible to connect a AIR-LMC352 to an AIR-ANT3549 and if so what part or manuf. cable would you use to conenct the MMCX on the card to the RP-TNC connector on the antenna?My hope is to use this to communicate back to a 350 Series bridge in AP ...

I have heard that the Aironet AP's don't play nice with Funk's Steel Belted Radius Server. Has anyone had an experience with these products or anything you have heard about this problem would be good to know. I have a customer that already has Funk's...

Hi--i'm trying to use the latest security enhancements to our 340 image (Enhanced MIC verification for WEP, and the Temporal Key Integrity Protocol). But everytime i turn on those new features, the clients associate fine, but IP appears dead (no rout...

Is it possible to pass DLSW/SNA traffic through PIX.If so can u please tell me how to configure it or is there any information in cisco site.Thanks.

If anyone could help it would great, i have a 350 ap set up as a repeater to another ap. at times i get this error message "Network bridge loop: received packet from self destined to {workgroupbridge1} on port rptr1"What does this mean and how can i ...

I currently have a 350 ap 11.10 firmware with 2 workgroup bridge clients running 8.65 firmware. The ap is running LEAP with cisco secure acs 2.6. when i enable dynamic wep, my clients show in the association page that wep is enabled, but i lose all c...

I'm looking for a portable battery pack to use with ap350 and br350 when doing a site survey. any recommendations, manufacturers, etc.?

350 is working fine with inline power injecter, but it keeps reloading when connecting to 3524XL with inline power.is there anything special for this approach?

Can anyone recommend a good WLAN sniffer tool?

After reading about all the vulnarabilities of WLANS I am unsure if any are good enough. The latest is dynamic WEP, Temporal key integrity protocol, and Message integrity check. Are any of these good enough to use in a military application. Is EAP go...

Has anybody managed to find a solution of managing updates to client firmware, drivers and ACU?Given a large campus deployment and changing technology what approaches have people taken to address this issue?I know that Wavelink have a product that he...

Is Cisco going to provide TKIP for my 340 series bridges which at the moment are providing 11Mbps (approx 5Mbps throughput), 128bit wep encryption, broadcast ssid turned off. Each bridge uses a different key for transmission. The whole thing is worki...