Hey Community! I'm excited to share something we've been working on that I think will really resonate with many of you managing wireless networks today. We just released the Cisco State of Wireless Report 2026, based on insights from over 6,000 wirel...
Forum Posts
Resolved! Change DNS settings on AP's with API
Hi,I configured around 180 AP's in 1 organization with static IP addresses and static DNS. I would like to change only the DNS settings for all AP's, using API (with Postman app). I cannot change to DHCP because of monitoring systems. Anybody got any...
Resolved! Wifi disconnect troubleshooting help
wireHello,We have a Cisco based wireless enterprise based on 5508 WLC's (Firmware: 8.5.171.4). We are struggling with periodic "disconnects" of Windows based clients. I'm not a cisco expert, but am fairly well versed in WLAN's in general and Window...
Resolved! UNII-3 in Belgium
Hello all,Does anyone know the regulation for UNII-3 in Belgium.I have read in the Meraki and other forums that UNII-3 is allowed in other European counties, but I am not sure what the situation is in Belgium. I assume they all follow the ETSI standa...
In every release note: Sporadic packet loss & instability on Layer 3 roaming & Teleworker VPN SSID's
So have people encountered this loss? For a long while I have been and still am hesitant in updating the firmware as we use L3 roaming.And in every release note it is mentioned
We need to disable this in our environment and currently we have to do this one ap at a time. Can we configure this via WLC so that any AP that joins will have this setting? Note that we are using C9130AXI-B AP running on 8.10.185.0 code version and ...
Hello, guys. I'm having a problem registering an AP 1852i on the controller. WLC VER-8.5.151.0 It already had a registry but after a reboot of the controller, when it tries to register, the following errors are listed:*05/14/2023 17:08:53.0150] CAPW...
Salam,I have converted one Access point from capwap to Mobility Express by TFTP server. Now i have web access as attached below pics. I need to add another access points to this AP Controller, but when i am getting error as attached.I tried also for ...
Hello, i have an issue with an installation involving AP1850 and software 8.8.100.0. Out of the 15 access points, 3 are not showing up in the controller. These three access points have been in their boxes for 2 years, and now we have tried to put the...
Hi All,We are a meetings center so we run custom WIFI networks for events and conferences. We have been using PI for years for reporting and that has been great. We are now upgrading to 9800 controllers and with have DNA Centre. What is a good want...
I have a small network with three Cisco 240AC APs.Recently some client devices have failed to connect. One such device is 2c:9e:00:56:d9:86.An extract of the log is below. *apfMsConnTask_0: Jun 05 18:37:31.035: %APF-5-CLIENT_ASSOCIATE: apf_80211.c:1...
Found Hardware Faulty for Cisco AIR-AP1852I-S-K9C and cant power up
Hi thereI can't access my AP. Initially green light blinking then Red and OFF.What is the solution ?
Resolved! C9115AXI-A
Hi Team, In C9115AXI-A do I need to have a controller for this? Or this AP can run without controller? Thank you! -Mike
Hi,I wanted to create two ssid with same name and encryption but both the ssid on different VLAN.Have created two AP group and can map to each of the AP and wanted to roam between to AP with same SSID/encryption but different VLANs.When I roam to ano...
Some of our access points have problem recovering after a power interruption (No UPS). The clients connected to it are getting the IP of the Access Point as DNS. We need to restart the AP to restore the correct DNS of Clients.- We have a separate DHC...
