Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
Hello,is it possible to register an AIR-AP1562 under a 9124AX-EWC ?If yes, will they be able to operate together in mesh mode?Thank you
When trying to setup an EAP-TLS connection for my Wi-Fi authentication. I have to install CA cert and a user certificate in my device. This use to work perfectly fine until I upgraded my phone to android 11. Now , my phone doesn't gets authenticated ...
Hi everyone. I am facing an issue. We have 2 networks (2 3850). Vlan 17 for wireless (aruba)and vlan 18 for wired. Both networks have different internet connection. Both switches are connected to a 2960 to connect to a remote switch 2960 through fibe...
delete
we purchased some AIR-CAP2802E-A-K9 APs to replace existing 2702E APs, we checked approved antennas with Access Points 2800 on Cisco website and found all the antennas are multiple connection (four cables), as we are using antenna cables (5 - 25 mete...
Hi there, We have a single AP out of about two dozen that is often disjoining from our WLC. We have noticed that it disjoins every 15 minutes or so and then re-joins again. We have tested both patch leads on either side and of course the whole line. ...
Resolved! Access Guest very slow at some APs
Hi WLC 5520 with ver 8.10- and about 30 APs 3802I (FlexCon)are joined to the WLC via the same model switches connection. Each switch is connected with about 5-9 APs and all these switches are connected to the same core switch. There are NO any issues...
I have a CISCO 5520 WLC, Cisco Switches, MacBook Airs, ipads and apple tvs. Our setup works to allow any mac and ipad to screen share to any apple tv all through the wireless. However, I just added 11 BenQ Touch panels, "big computer monitors that ar...
Resolved! Aeronet 2600 boot loader issue
Hi My aeronet 2600 ap not booting due to missing boot loader, I've tried thru console and crosscable but timed out error . Also I've tried all option that I could've find on Cisco Community but can not find any success option from web. Please help me...
Hi All ,I have a Cisco AP model C9120AXI-E with embedded wireless controller v17.3.1 .Does anyone know how I can enable multicast on cisco embedded wireless controller or is there any way to enable it?Thanks for any help
Hi, we are trying to put together a test bed to experiment with Hot-Spot 2.0/PassPoint,it would probably has one WLC and 2 APs for now, could someone please recommendsome modes? also if there is a list of Cisco WLC and Cisco APs that support passpoin...
Resolved! 1242AG multiple SSID on multiple VLAN
HiHave following setup on a 1242ag (autonomous):SSID 01 assigned to VLAN120 Radio0(2,4GHz)SSID 02 assigned to VLAN140 Radio0(2,4GHz)SSID 03 assigned to VLAN 130 Radio1(5GHz) To see the SSID's I have set guest-mode on SSID 01 and SSID 03.But when I tr...
You can use two Embedded Wireless Controller in the two switch Catalyst different Edge nodes (C9300) (version 17.3.3) and package wifi (C9800-SW-iosxe-wlc.17.03.03.SPA) on my server DNA Center version (2.2.2.6) I installed package wifi in the edge...
Hi,I have 5508 WLC in DMZ as ANCHOR and 8540 model as internal WLC, the Guest WLAN was working fine and the mobility anchor was up, suddenly I found the mobility status as (Control and Data Path Down) and Guest Wlan stop working.please your guidance....
We have encountered new issue that, Mobile are not getting connected with WiFi network and it was working fine before 1 week. WLC model is 5520Laptops are Still working fine.It will show trying to connect when we try to connect mobile devices.one of ...
