Hi All, I'm setting up a Cisco 9800-CL WLC and I want to check if there are any issues with using a single VLAN/IP for both WLC and AP management? We currently have a management VLAN that is presented to our ESXi hosts and we dont want to setup a se...
Hey Guys, i noticed that one of my APs (2702i with 8.10.185) in a remote branch office decided not to serve any 5GHz clients. Upon some investigation i found out that its 802.11a radio is admin UP but oper DOWN. AP is powered via PoE and has full pow...
Hello Professionals,I'm configuring 3 SSIDs and those has same security conditions. (WPA/WPA2 - Macfiltering)I would like to grant different connect rights for each devices. For example) - SSID: AAA - SSID: 123 - SSID: 000and there are 2 client de...
I have installed the embedded controller image on C9115AXI-D access point and working fine till it is rebooted. once rebooted it boots in to IOSXE image but no connectivity (no ping no http or https). gig0 interface is up but self ping also fails.I h...
Hiwe are getting this error from a cisco C9120AXI-E (V07) AP, when talking to our WLC.[*03/08/2023 16:04:57.4903] CAPWAP State: Discovery[*03/08/2023 16:04:57.4903] IP DNS query for CISCO-CAPWAP-CONTROLLER[*03/08/2023 16:04:57.4923] DNS resolved CISC...
I'm having an issue where the wireless guests are disconnecting after 15 minutes and are prompted to log back into the captive portal.These are the configurations on the Mobility Express Controller. Can someone please advise if theire is a setting th...
Hello Professionals, I have a question about DHCP snooping with trusted port. I have Cisco 9300 switch and wlc9800 controller is connected to this switch.Wireless client can get IP address from the DHCP pool from C9300 switch.When I tried connect SSI...
Hi All, I am looking to restrict per client user bandwidth for our Guest network on Cisco 9800 WLC's. AP's are in Flexconnect mode.IOS version is 17.3.5aIs this possible on catalyst WLC like Aireos based WLC's? -Kamal
Dear Experts, Hope all are well, I need some some info if some one can share it woul be great!I am looking for Posture, CWA and WLC integration configuratoin if someone can share the configuration steps it would be great.Warm regards.
Hi,Does 9800-CL wireless controller will work on Nutanix? I didn't find any official supporting document.
Hello Professionals,From 2 days ago, my wireless controller (WLC9800-L) freezing suddenly.- version: 17.9.3This device is directly connected to C9300L switch port with Trunk - Trunk(with allowed port).I was accessing Web GUI of controller, but sudden...
Hi,We would like to build a small WLAN network. Therefore, we would like to purchase one WLAN controller and (at least) two access points. We need the WLAN network to support at least:-Wi-Fi6E 802.11ax-Fast Initial Link Setup (FILS) 802.11ai-Fast Tra...
Hi,I have a Cisco AIR 1131 access point(firmware is c1130-rcvk9w8-tar.124-10b.JA3), when i type cli command : sh ip int brthe following syntax appears : FastEthernet0/0 is up, line protocol is down! Please help me fix this error.Thanks in advance.
HI,WE HAVE A CISCO WAP-131 BUT AFTER A POWER FAILURE, THE ACCESS POINT HAS THE POWER LED BLINKING AND DOES´NT WORK, CAN YOU HELP US PLEASE?BEST REGARDS,JUAN M. QUINTANILLA
Hello,About 1 year ago, to expand WiFi coverage, we purchased AP Catalyst C9115AXI-E. As the version of the WLC 5520, in SSO and CAPWAP, did not support the new APs, because of the AIR-CAP1602I-E-K9 series AP, it was decided to make use of the EWC th...
