Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
Resolved! Correct country code to join AP with WLC
Hi Guys I have two cisco APs. Its model is AIR-CAP2702I-S-K9. I need this two APs to join with my vWLC. So what should I configure the country code of vWLC to join those APs. My vWLC's default country code is US. Thank you.
Hi, Does anyone tested the Cisco 3504 WLC HA SSO? I've tested the setup in a standalone network were the two WLC is connected to a switch and HA is working fine but when the WLC is connected to actual setup i've encountered peer communication down ...
Right now the fastest speed everyone receives is around 144 mbps. I could change the band over from 20 mhz to 40 which should double the pipe but i want to know if its even necessary. When I look at my laptops stats from within the controller this i...
Resolved! controlleur with IOS 8.2.170
Hello i have a controlleur with IOS 8.2.170 and AP 1815i so what ios that i can downlod in controlleur that allow work to 1815i OR what IOS in 1815i that allow work with controlleur 8.2.170 ????,, please , i need a help about this ^problem !! t...
Howdy... I have an old 2504 controller that has performed faithfully until... well, recently. We have an upgrade to HA 3504 controllers coming up within a few weeks (yes, including service contract) but until then I will need to make things happen w...
Hello, I have a wireless AP 2800 which is not getting an IP address from the Primary controller name and IP All my other APs are working ok to the same controller namely 10.4.3.11 Incidently its stuck on a green light even after a reboot I can ping ...
Hello, I got 5000 of 3802i Aps, I would like to stage them with static ip add and WLC ip add also. is there is any tools can help me to make my work faster with out console each one and push the configuration on it?? Thanks,
Resolved! AP Distribution by AP Model
AP1131's max speed is about 27 Mbps, which is very slow. If we want to upgrade it, which AP we can use to replace it? thank you
Please provide the proper guidance/documents for setting up a new CISCO Prime Infrastucture appliance. I'm setting up CISCO Prime Infrastruture 3.4 appliances (PI-UCS-APL-K9) in near future and the documentation is a little difficult to follow. 1 - ...
Hi All, Here i have an 48 Port C2960-X PoE.I connect the PBX's, and 3 Aruba AP's.But the the problem is Aruba AP couldn't get the exact power,It works under power save mode. I have a question , Why this PoE can't supply the exact power for the Access...
Trying to understand whats significance of the Virtual IP interface in WLC. The default ip set is 1.1.1.1 and we do have a public dns which points to that ip now. Does this mean redirections for login will fail because before login itself system will...
Resolved! Cisco 5508 wlc guest access
Hello everyone, I have a Cisco 5508 wlc and i would like to create a guest wlan. Is it possible by using the WLC the following: The IT department should be notified in event of guest wifi access request for a new guest computer(MAC), and the IT ...
hello, i have a problem with configure air-ap2802i-e-k9 standalone, i have a tar file but I have a problem. when i tried to upload a the tar-file via TFTP. I have the message "Error, image file size is smaller than image + key + signature 0x022f6000 ...
I have un AIR-CAP1602e and i have bought other AIR-AP1852 with mobility express.Originally air-cap1602 had version 15.2.2 autonomous, after i have upgrade to 15.3.3JF lightweight.The mobility express have version 8.5.131.0.Now mobility express finds ...
