XR OS and Platforms

Hi Experts   This is the config we have on ASR9K, running IOS-XR. NTP works fine in single VRF. However, on other VRFs, the NTP doesn't respond. We traced packets in NTP debug, no luck. Any special cmd needed, apart from the below? When application s...

9k folks...is there a cute command to see the mac address table per bridge domain WITH all line cards?   that is to say, not per line card?sho l2vpn forwarding bridge domain BD_Group:domain mac-address location 0/2/cpu0   works but when our bd spans ...

Dear All, can you please suggest if we can use management interface of ASR9910 for copying IOS-XR image and SMUs?    

hi I am getting this fan speed , is that abnormal :  Fan speed (rpm) and run time (in hours) :        FAN0    FAN1    FAN2    FAN3    FAN4    FAN5 0/FT0/* (Speed)         12960   12600   12300   12330   12570   118500/FT0/* (Run Time)         N/A    ...

Does anyone know if MC-lag is supported in latest IOS XR release for NCS 5500 series.  Or has it been replaced with EVPN Multi-homing?

Anyone know how to set IFE port-group to 1G on a A9K-24X10GE-1G-TR ? Seeing this  module's ports are configured in IFE port-groups(https://www.ciscolive.com/c/dam/r/ciscolive/emea/docs/2018/pdf/BRKARC-2003.pdf) After significant searching I can't fin...

Hi , Can i put two CGSE cards in one chassis and somehow to bundle them to get 40GE ? Kind RegardsVZ

HelloI got the following when trying to configure SSH on an ASR9K:RP/0/RSP0/CPU0:hk4-vipasr1(config)#ssh ?                                     ^% Invalid input detected at '^' marker.RP/0/RSP0/CPU0:hk4-vipasr1(config)#do sh install active  Node 0/RSP...

Hello,I am getting an error while booting the linecard : PLATFORM-NP-0-INIT_ERR : Device BST memory test failure 0x80001761 on NP channel 7 external TM memoryThere are a lot of other errors but I think it's the one related to my issue.It does a kerne...

Hi AllI am trying to upgrade my IOS-XR from 5.3.2 to 6.2.2, but fail with following errors, anyone can assist me on this , i have all all the PIE in the install , and install activate causing this  : \ 1% complete: The operation can still be aborted ...