Hi everyone：
these days，i have met a problem that is our MSC and SIP-800 line card look like have some error in slot 0/0.we can see MSC when we use “show inventory” command，but we cannot see MSC when we use “show platform”.So we run a RMA with MSC ...
Hi all,
I would like to set up VRF and route-leak. But, for unknown reasons, routing between global and VRF RIBs does not seem to work.
Below is my running configuration:
!! IOS XR Configuration 6.1.2!! Last configuration change at Wed Oct 24 1...
Hello guys
I have a DC fabric with NCS 5508 DEVICES runing is is as IGP , when i see the routing table i see the following output
i L1 10.190.116.0/32 [115/11] via 10.190.117.14, 8w2d, Bundle-Ether203 (!) [115/10] via 10.190.11...
The Cisco documentation for Link Bundling on the ASR9K routers says:
Multiple links can span several line cards to form a single interface. Thus, the failure of a single link
does not cause a loss of connectivity.
Since each line card has its own...
All:
Is there an equivalent command to "describe" that allows enumeration of required taskgroup requirements, but for the XML API?
The CLI Command "admin show inventory" seems (to me, to be) analogous to the following XML query:
<?xml version=...
I currently have an ASR 9010 running IOS-XR 5.1.3 with a A9K-RSP440-SE, A9K-8T-L, and A9K-40GE-L. I'm attempting to create an egress ACL for IPv4 and IPv6 traffic exiting my network.
object-group network ipv4 ipv4-permit-smtp
1.1.1.1/32
!
ipv4...
Hi, I'm looking support and clearify the procedure for the Software Upgrade in IOS XR from 5.1 to 6.4; I understand the procedure needs to go from 5.3 to 6.4 using TURBOBOOT, but i didn't find anything from 5.1 to 5.3 or 5.1 to 6.4.
I'm planning the ...
Hi,After upgrade to 5.1.3 on a ASR9001 router we are receiving these messages.RP/0/RSP0/CPU0:Jan 20 07:06:41.800 : snmpd[1128]: %SNMP-SNMP-3-INTERNAL : Snmp Trap source issue : Using best possible Src IPV6 address for SNMP Traps. Failed to get the IP...
I can reverse telnet and SSH to a Cisco ASR 9000 (XR 5.3.4) but after entering my password and pressing enter, I am unable to enter any more commands therefore we have lost management capability to our device. I did find a command to show the active...
Please I need assistance, I cannot access the 20 1GB PORTS and the 4 10gb ports from global mode. I have administrative right to the router.
However, if I type interface preconfigure gig0/0/1//1 from the global mode it will take the command but ...
Dear all
One of our ASR9010 router has alarm as below.
RP/0/RSP0/CPU0:Oct 9 09:57:42.686 : shelfmgr[416]: %PLATFORM-SHELFMGR-0-MAX_RESET_BRINGDOWN : Can not boot node 0/RSP1/CPU0 A9K-RSP440-TR due to multiple resets, putting it IN_RESET state. The ...
Hello AllI am trying to check route leaking between VRF and default routing tables in IOS XR. Specifically I would like to have PE router without using any "hairpin" interfaces to be able:- To "leak" traffic received through a BGP VPNv4 destination (...
