Application Networking

we have a csm card in a 6513. A small serverfarm is configured with two real server and the vserver is configured as well, pointing to that server farm. We have a sticky of 5 define with the vserver. When we bring down one of the web server it takes ...

Hi,Assuming the performance was good enough, would the below be a viable alternative to the CSS11501? I'm guessing it's the CSS's hardware architecture that bumps up the price?http://www.brainforce.com/eng/produkte/ina/ina_b100_cont_eng.htmhttp://www...

We use two redundant CSM-Modules with version 3.1(6). Now we have the need to check the content of a website in a probe configuration. The serveradmins shall have the possibility with a change of a value in the website bring up or down their server (...

I can virtually send any traffic with any port to the content engine to be cached through the wccp service-number command.I tried to use that feature to cache SMTP or POP3, however, it does not work.The TCP handshake is redirected to the CE through W...

I am pretty new to Content switching. I have a situation here at my office that I would need some help with.I have an existing 11050 box that I am replacing with a new 11501 running ver 7.2 (the 11050 runs 5.0) and an additional 11501 to be brought i...

Hi All,Currently we are using CSS11155 to load balance the traffic for our server farm. The diagram as follow:firewall (10.10.10.1/24) | |CSS11155 (VIP: 10.10.10.100/24, VLAN1: 10.10.10.254/24) | |Servers (Default Gateway: 10.10.10.1/24)Now I...

With using a CSG content service gateway in a mobile network can I configure an inactivity timer (without traffic the user is disconnected after xx minutes)thanks

Does ACNS 5.1.1 support authentication via LDAP with Windows 2003 servers? If not, does a newer version support that?Thanks. Thomas

Our netmodule has been successfully installed and working. Its currently running 4.2.3 and we would like to upgrade it the latest 5.1.9.5 rev. I cannot find a working procedure for doing this. When I attempt to ftp into the module's IP I get a err...

Hi Can I do WCCP redirection on a GRE Tunnel interface?And not on the actual serial?Any info would be greatThanks

I did suspend a service to update some configuration issues with the web server and I realised that the server couldnt go on the internet to do such. I was able to do that when I had the same server connected to older 11050 but couldnt do such with t...

I replicated the configurations on CSS 11050 box on a new CSS 11500. The configuration is shown below ip redundancy master ip route 0.0.0.0 0.0.0.0 192.168.2.2 1 !************************* INTERFACE *************************interface e1 phy 1...