So not sure why I am having this issue and checked a number of items... I have a Cisco DNA appliance DN2-HW-APL-U, and updated to the latest firmware, for DNAC running version 2.3.5.5-70026 but when I go to the software management it is not showing t...
Forum Posts
HiWe have a Cat9800 already added to Catalyst Center without learning the config. It has a load of telemetry settings already in place pointing to, I think, a Prime system via its IP address. I had a look at what Cat Center pushes out if we push te...
C9500-40X: ERPSAN and SPAN: can a configured ERSPAN source session have overlapping sourde ports with a local SPAN session? Best Regards!
Resolved! DNAC API limits
Hi,We are using API call /dna/intent/api/v1/business/sda/hostonboarding/user-device to retrieve static port assignments to VLAN.In DNAC the API call page states that API Throttling is 100 calls per 1 minute, but in reality, we are seeing API Throttli...
Hi Expert: There seems that have some limitations of using api by 5 times/minutes? It affect our application visualization when we want to frequently get information from dna center. cloud you tell me how many time slot between two using api Than...
hello I have a few questions when connecting VSS for the first time through VSL. 1. Whether to reboot the switch when connecting for the first time2. Whether to initialize the previously set CONFIG when linking for the first time3. Measures to minimi...
I have went through all cisco documentation related to DNAC Deployment using AWS CloudFormation and it says that we can only configure an on-premises NFS backups. So the correct way to run backups would be creating a VM on AWS to simulate an on-premi...
Our aim is to send email notifications when an interface of the DNAC managed switches goes into errdisabled state. I understand that it is possible to subscribe to Events, however I cannot find any event under Platform -> Developer Kit -> Events whic...
What is the correct way to onboard a pair of Cisco 9500's intended to become a stackwise virtual pair?I have been able to onboard them individually with a template that contains the configuraiton for creating the stackwise domain and neighbor peering...
Hi Everyone I have 2 ADNC devices and 2 ISE devices located in DC, DR. Can I cluster between 2 DNAC and 2 ISE and how? Because currently the company's website is asking for cluster 3 devices
Resolved! Multple Router types per Site
I'm setting up router profiles in the Cisco DNA Center but I have multiple router types in a site. As far as I understand the logic, you can have:- one router type per Routing Profile- one Routing Profile per Site Is there a way to add multiple route...
Hi, I'm deploying DNA-C on AWS for a client and am running into some issues. Rather than connecting the AWS VPC back to an on-prem Firewall, we want to connect it to Prisma Access, so I'm setting up a Transit Gateway in AWS. When I step through the...
Hi Team,Is it possible that I can use Catalyst 9300 for StackWise, StackWise Virtual and VSS?
I received a 9200L from the field that was factory-reset. I tried to do an emergency-install from USB but it is not a valid command. So I then tried boot usbflash0:cat9k_lite_iosxe.17.09.04.SPA.bin and it seemed it was going to work, but now it is st...
Hello, SInce the 3 nodes of the cluster have been restarted, there's no more logs audit logs. Installed version:2.3.5.5 Is it possible to restart the dedicated service without opening on more Cisco TAC Case ? Thank you,
