Cisco Catalyst Center

This community is for technical, feature, configuration and deployment questions. For production deployment issues, please contact the TAC!
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Don't miss this Cisco Catalyst 8000 offer

 
Labels

Forum Posts

HiCan anyone advise on the knock on effect of me changing my DNAC cluster name?  Does it affect the existing integration with ISE and with the devices in an existing SDA deployment?All I can find is that to change the name I use the # sudo maglev-con...

KevinR99 by Level 1
  • 630 Views
  • 1 replies
  • 0 Helpful votes

HiI have an AP pool in my DNAC and as expected when I plug an AP into one of my access switches the port is auto configured to put the AP in the correct address pool.  However, I have 9136 WAPs and they support LAG on their dual uplinks.  Is there an...

KevinR99 by Level 1
  • 552 Views
  • 4 replies
  • 0 Helpful votes

I'm trying to start a session using an SSH client and send a netconf command to the switch.The request was sent successfully, but there is no response from the switch.[root@localhost ~]# sshpass -p **** ssh -s admin@[ip] -p 830 netconfUser Access Ver...

  Hi all. I have a question. Are there any documents or info regarding memory utilization thresholds for DNA appliances? For example OK : Memory Utilization (< 50%)Warning: Memory Utilization (51-80%)Critical:  Memory Utilization (81-100%)   Thanks 

RezaFH by Level 1
  • 319 Views
  • 1 replies
  • 0 Helpful votes