Cisco Modeling Labs Discussions

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Forum Posts

Hi There,  I have been doing CISCO routing and switching training. I want to ask this question for while. After I load some basic config for OSPF network, I just cannot use the command "Show run Interface FastEthernet0/1" for example:  r3#show run in...

I have been unable to download CML PE as when I go to download I get the following error:   You are not authorized to download the CML PE software because our record indicates that your CML subscription has expired.Visit the Cisco Learning Network St...

ehoney by Level 1
  • 925 Views
  • 0 replies
  • 0 Helpful votes

I (from laptop on wireless connection) have been trying to connect my edge router (within the CML Lab environment) to the Internet using an external connector "cloud" node. I understand that you can bridge your physical network to the topology networ...

Hi All, I'm using CML version 2.2.3+build63 and I have lab with 16 routers and switches. I have this setup as it represents my production WAN. I test out new configs and possible work changes however, I have to go back and undo the config changes or ...

dan hale by Level 3
  • 1700 Views
  • 3 replies
  • 0 Helpful votes
Top Solution Authors