Metro

Hi, I've run into a very annoying issue that I'm having a hard time understanding.  In short, our ISIS metrics on backbone links (dual-stack) are being automatically adjusted to the max ISIS metric size (16m or 33m) despite the fact that all of our l...

Hi,   Am trying to configure mac-based vlan for inband managemnet on me3400 and didn;t find any configuration guide, can you help with that. =Khalid

I'm looking at setting up some ASR920s with mLACP, I followed the configuration guide for mLACP - https://www.cisco.com/c/en/us/td/docs/routers/asr920/configuration/guide/lanswitch/16-12-1/b-lanswitch-etherchannel-xe-16-12-asr920/b-lanswitch-ethercha...

Hello team,   I have a concern regarding a request from one customer to enable link integrity/Fault signalling. Basically they subscribe for 1G link from point A to B. What they want is , If the port at location A somehow goes down the far end port  ...

Hi,Could anyone share with me a working configuration example (CLI) of H-QoS in EVCoEtherchannel in ASR1k?Notes:   - H-QoS: Parrent: shaping, Child: CBWFQ   - EVCoEtherchannel: Service instance subinterface in portchannelThanks in advance

Hello,it is possible to get information "show subscriber session username XXX" via snmp? i am looking for QOS/ACL active polices on concrete subscriber. The second question is, can i via snmp v3 use too clear subscriber session XXX command to load ne...

Has anyone seen IOS-XE specificaly on a NCS520 produce a frame src 3aff.fe80.0000 dst to 6000.0000.0010 ?

Hi,I have configured client with VPLS between our DC's.  Our device is moaning about multicast storm from the client and i would like to SPAN this physical interface, however, it is configured as an EFP. Does anyone know if it is possible to SPAN thi...

Hi, I have a case where I need to establish a CFM session between a downward MEP and upward MEP. Is this possible? Or CFM session is always between either two downward MEPs or two upward MEPs. Any reply is much appreciated.  Thanks

Hi all;I have a carrier network with NCS 5501, we deliver L2VPN service to customers, how can I configure NCS 5501 UNI interface which is Bundle-Ether interface to process LACP PDU locally ?Note that for my service, customer promise equipement (CPE) ...

Hello everyone,I am a newbie to Cisco ASR 1001, I have some basics questions:Please consider   Cisco ASR 1001, version 16.9 for following questions:1)interface Overlay1no ip addressotv join-interface TenGigabitEthernet0/0/0.4000otv adjacency-server u...

Hello colleagues,Could you please help me with one small question. I'm installing 10G license on ME-3600X-24FS-M. This is what I've got before installation:Switch# sh license...Index 3 Feature: 10GEUpgrade        Period left: 8  weeks 4  days        ...

Dears,Kindly advise difference between 1- uni port vs access port ?2- nni port vs trunk port ?Many ThanksBR,Sherif Ismail

Below is a sample layout of my network, i currently have a few locations connected via L3 VPN, these services are trpically delivered via a pruned trunk link to  the client location with VLAN 100 being my management VLAN to gain access and to monitor...