MPLS

So I've found ways to exchange routes between VRF's with a BGP Af configuration, as well as the global keyword on static routes, but what I'm trying to do is to get connected Global routes into a VRF, is this possible? If so can someone point me in t...

Hi,I just want to know in MPLS VPN where you have MP-EBGP multihop session between PEs not ASBR... so when do we need to use set mpls-label to set the MPLS label... as we are using send-labels on ASBRs... Actually I want to know in which case or scen...

Hi,I had P router previous enable the LDP with other peer routers. No password is configured for the peers session. No neighbour command.Now I would like to add more routers and connect to this P routers via STM-1. But new requirement is the LDP sess...

Dears ,Im trying to create MPLS VPN for my ADSL subscribers . I'm sending the vrf config. from the radius and On the radius debugs I can see that see that configuration is sending correctly to the router , but on the router Virtual access interface n...

We are an IP Transit provider, eBGP connection to our ISP upstream provider. We have multiple STM1 connection to our ISP upstream provider. Our upstream provider propose to sell us MPLS VPN and IP over the existing connection to connect our local MPL...

Any body can help me how can we calculate route reflector in MPLS domain where 16 * 2 distributions(PE) exist.

Hi All, Does VPLS is supported ,if the core links are in 10 gig 6704 module MPLS enabled ?Any assistance on this would be really appreciated .RegardsAnantha Subramanian Natarajan

One of our customer sometimes experience a loss of connectivity on a certain network prefix but this network prefix is reachable from the CE router and is present on the local router. From the local PE router the network prefix is reachable but from ...

ip rsvp bandwidth xxx? or something else?how to maintain the relationship?

Hello,I'm trying to setup a gre tunnel over my mpls network in a VRF called Intra. Here is my conf. It's weird because the tunnel protocol is up on one side, down on the other side.I can ping the destination ip address on each side.interface Loopback...

Hi,How to convert the IOS to XR ?In XR I use this command, but don't know how to tight to Route-Policy ... no set extcommunity for SOO.RP/0/RP0/CPU0:router(config)# extcommunity-set soo setDCNsooRP/0/RP0/CPU0:router(config-ext)# 65000:123IOS---------...

I've been going through all the documentation regarding MPLS and configuring MPLS QoS on PFC's and I'm stumped on this question.In the past MPLS networks I've used Pipe Mode with Explicit Null LSP to configure QoS within the MPLS network. The benefi...

Hi All, We are trying to understand the way QOS works on inter-AS VPN option C deployment. Assuming there are three MPLS vendors,name it as SP1,SP2 and SP3. The customer site are hanging between SP1 and SP3,Where SP2 act as a pass through (i.e C1-SP...

Hello,I was trying to run multicast VPN on 7200 and 3640 routers using dynamips...Here is my topology:CEA---PE1---P---PE2---CEBnow at very first i used all router as 3640... and i eanbled PIM SSM on PE1, P and PE2 router... i have vrf CE with same rd...

I am looking for the best understanding of GMPLS and TMPLS. Can anyine share the basic documents.regardsshivlu