MPLS

I am implementign a MPLS connection to my company and I faced the following situation:Is that possible to have, as CPE, two routers connected to the same MPLS provider, and have the same two CPE routers also connected to the same VLAN at the customer...

hi all!is it possible to use MPLS with a Cisco 1721?If it is possible, what featureset shoud i use?How could a MPLS-Config look like?I hope you can help me!thxRichard

hi there,just wondering, how to we determine that from PE to PE routers from the lsp path point of view? Any show command would be useful? I found that we could only verify using MPLS OAM..any other method perhaps..thanks in advance.maher

I have two 7200 routers ( 7204 and 7206) ans MPLS VPN, with a VRF for each client .A 7206 router have a interface ATM 155 Mbps where all customers connected to him through ADSL lines.The NAT does not make the client, it is implemented by tuneles betw...

Hi,One of my customer currently connects to three different MPLS providers. All the SP's PEs are already configured with the customer's subnets, but the CE is configured to point only to one of the PE as the default route. If the link to this SP is d...

I am cutting a frame-relay with ISDN backup Network over to MPLS with DSL Backup - I want to use OSPF on the MPLS and EIGRP over DSL; I have a mixture of routers 1750, 1751, & 1760. I have been doing my DD but was wondering if anyone here has done t...

Hi, Is there any single point or a way to monitor all the connections in MPLS cloud. Like there are 5 Sites connecting to each other in MPLS and if any site wants to send a packets to remote sites then it directly sends the packets, as this is not a ...

we have a MPLS VPN backbone, topology is normal fabric:PE1--P--P--PE2 PE1 cisco7206PE2 cisco 10720PE1 have a vrf subinterface,ip address is 133.147.240.17/30,loopback0 172.16.20.2PE1 have a vrf subinterface,ip address is 133.147.240.5/30,loopback0 17...

Hi.I have a PE router (7206 NPG-1) which splits customers into vrf´s. And then into VLAN´s on the way down to switches for customerserver access (or what ever..)Now, I would like to have the possibility to offer a service from one server behind one o...

I work for a small SP, we have an existing plain IP core, and I am trying to implement MPLS.My approach has been to enable LDP and MP-BGP on a few links and watch what happens first, and implement VRF's later.When I enable LDP and MP-BGP, some applic...

Help me, please.I am Service Provider.I have the following scheme:http://x.surguttel.ru/forum/tmp/vrf_vlan.gif (9 Kb)How can I connet the customer's PCs and the customer's LAN? I need the customer can use any IP addresses (may be overlaping with my n...

I'd appreciate it if someone can send me a sample configuration of commands that need to be run on the MPLS VPN Core & PE routers in order to support Multicasting using a Multicast Domain Solution. Thanks.

we are planning to connect our network with an MPLS backbone. What is the preferred routing protocol to use between our CE and the provider PE? I heard that all routing protocols are supported (OSPF,IS-IS, RIP EIGRP) is that correct?Also, if we use V...

I am marking packets with dscp on the edge of the network but after the packets have been through the mpls core (6500's with sup720's) only the equivalent ToS value is in the header.Anyone know of a way to preserve the full DSCP value?