Network Management

Hello all,Does anyone know what or where I can find the OID for enabling and disabling a port for the RV016 router?  I performed a snmpwalk but I couldn't find it.  Am I missing something?Thank you in advance.-Gil

I am monitoring devices with a software called zenoss, the Oid which is using to collect the temperature value from the router is 1.3.6.1.4.1.9.9.13.1.3.1.3. but when zenoss tried to collect temperature value from the cisco 2811IOS 12.3(11)T11, it di...

I need to create a route between two different MPLS clouds hosted by different providers.  These clouds are not aware of each other so I need to direct the traffic myself.Simple View:Host1 - 10.52.124.100             |Router1 - 10.52.124.3           ...

Hello,Does anyone know how to configure in a 2950 or 2960 snmp in order to send traps regarding cpu and memory utilization?? I can't find it in the command line or in any document.Here is the output of the 2950:Switch(config)#snmp-server enable traps...

How can I add devices onto the customizable group1?  I am trying to creat a group of trunk ports and monitor just the up/down.  Thank you for your assistance on this.

Hello,I have a problem with a CiscoWorks server. If I perform a "Device Discovery", the server discovers several devices but I can not see them in the inventory dashboard. However, when I restart all the CiscoWorks services, the Inventory dashboard s...

Hi,We have just installed LMS 4.0.1 and started to discover parts of the network. After the discovery process finished successfully -  100+ new devices were added to DCR message - I was able to see the devices by clicking on their number but when I g...

PID VID : RV042 V03Firmware Version : v4.0.0.07-tm (Aug 19 2010 19:19:50)-----Ever since I setup my RV042 with load balancing using the Dual Wan system I have had trouble staying connected to some secure sites. After doing some searching I found that...

I'm writing a script that excutes some show commands with cli_write, the idea is to use cli_read_line to parse output one line at time, then using cli_read_drain after done reading the results of interest.However, cli_read_line always returns the ent...

Hello everyone,I found this community helpful many times before, and I`m testing my luck again This time I would appreciate some guidelines regarding proper network maintenance plan. I basically want to propose this to our management and senior IT p...

I need to log into about 60 routers, run the same show commands on each router, and copy each router's outputs as a file on my workstation. Can someone provide a sample TCP script to do those things? I'm not good at programming.Greatly appreciated.

Running VSS on 6509-eWe had the following waning below in the logs and less than 2 hours an event occured in which the transport between the CORE and Distro did not pass traffic.   Would like a EEM script to fire and shut down the module when this lo...