Network Management

Hi,I want to install CUOM version 8 with Service Monitor.I want to know if it’s necessary to have the sensor Cisco 1040 to use and configure Service Monitor or I can use Service Monitor without the sensor.Thanks a lot,best regards,Omar YUNSI

Hello,a question or more a problem with netflow exports on Cisco 2821's.I configured netflow export on a Cisco 2821 with IOS Version 12.4(24)Tip cef...interface FastEthernet0/0/0 description to XXX ip address XXX ip flow ingress ip flow egress duplex...

Hi,I am in an environment with about 300 workstations, all connected to stacked 3750 switches. I want to be able to do simple management on the MAC addresses allowed on each port without using the IOS manually or using complex scripts. Is there a GUI...

As suggested by Joseph Clarke, I started a new thread regarding Fault manager issues in our LMS 4 installation.The original post: https://supportforums.cisco.com/message/3233282The following menus do not open (error messages are shown instead):Monito...

Router 7606.IOS: 12.2(33)SRE1, or 15.0(1)S1. Can we use CA's eHealth performance monitor to poll the loopback int for avaliability stats?  is the loopback interface part of 'interface' mib and does it responds to stats like up/down or avaliabilty etc...

Hello,We are running LMS 3.2 and I am trying to access Common Services -> Server -> Admin -> Job Browser but it is extremely slow. Waited for half hour yet it is processing the response page.Please assist. Thanks.

Hi All,I set up a 2960G with IOS 12.2(44)SE6 and created a role-based view to be used by our helpdesk.  One of the things they need to do is add rules to a MAC ACL on the switch.  I've successfully created a view for them and can include and exclude ...

LMS 3.2 and Campus Manager 5.2.1 running on Windows 2008 server.  The best practices reports this deviation on trunked FastEthernet ports.

Hello,We are running LMS 3.2 on Windows Server 2003 and I am trying to do an immediate backup on an external portable USB hard drive with 500GB capacity.The backup folder size continuously stops at 1.06GB whereas the total size of CSCOpx folder is 24...