Hi all,When I do the inventory update for all the devices, I always have 3 switches which can't be updated for inventory. The inventory collection for them always say "Device sensed, but collection failed "I got IC_server.log for that switch:[ Mon Ap...
I moved from 2500 series routers to a switched network using a Catalyst 3750 and 3560 switches over the course of the last year. In my routed network I used MRTG to monitor traffic on my interfaces. In my switched network environment I have not bee...
Hi,I' am trying to achieve that when I do a "wr" a backup config is copied to my TFTP server.My archive config looks like this:archive path tftp:172.23.106.30/$h write-memoryWhen I do a "wr" I get this debug output:3550_poe#wrBuilding configuration.....
Is there a method for accessing the DCR direct? other than through LMS CS???I want to see if there is a way to enter an ENABLE username directly in the DCR since there doesnt appear to be a method within CS's...Bruce
I have an EEM script which produces some diagnostic output. The script is written to be initiated by "event manager run" and is running in sync mode. Script uses "puts" into stdout to produce the output. Everything is working fine, except when scr...
In which product i can get all the below,I have currently LMS 3.0 what i can pull from LMS and what i have to order for pulling all of the below reports.Network Availability within LANNetwork Latency within LANNetwork Packet Loss (within LAN)Netwo...
I need to tweak some SNMP Views and I'm having a hard time finding something like a best practice document. I've found plenty of references to the usual ip.21 and ip.22 exclusions to block the routing table and ARP. I'd like to locate something wit...
I have multiple 6509's that fail to archive their configurations. 50% of them succeed and the other half fail with this job status:*** Device Details for 140_6509 *** Protocol ==> Unknown / Not Applicable Selected Protocols with order ==> SSH E...
Hi,Having problems restarting one of our CiscoWorks servers since doing a Microsoft Patching session last night. (I am not suggesting that this is the sole reason for this. It could be coincidence)On our master server, which runs CS and RM, I cannot ...
I have CA service desk manager which contains CMDB for assets/inventory. I was wondering if CisoWorks can provide information in an automated fashion that can be used to update and keep the CMDB current.I'm interested to see device names, model, sera...
Cisco LMS 3.0 was running on a Solaris SPARC box. I uninstalled it using uninstall.sh from the Solaris LMS3.0 DVD. i installed it again and after the installed finished i rebooted by Server. Now i am unable to open the web interface of LMS. can anyon...
Hello, i have this problem withcisco AP12XX. Some of the AP works fine some not.I have checked the IOS version on two of them (one working and one not) it is the same version 12.3(7)JA1Thanks a lot for your help
Hello, Can someone tell me where I can get the xml file from Cisco's website so that we can run EoL/EoS reports? I tried the help in Resource Manager Essentials and it does show a link to the file on Cisco's website, but it does not work. Our ser...
