We are using a cisco IE3300-8T2S-E switch on our project. Can someone please help me with questions about the recommended fusing capacity for this switch below: Documentation shows that power consumption is 23 W at 12 V (for non PoE models) and that ...
Forum Posts
Hello all, If I login by "admin" I don't see on page left sidebar, but if login other customer user I see left sidebar.Help me recovery visibility this function.Thanks.
Hello, team.I am trying to configure Model Driven Telemetry on my ASR920 router (IOS XE 16.09.05f) but i got invalid status for it.I noticed that the IP addresses of Receiver (telegraf collector) in configuration file and in the show command are diff...
Can I configure a LAP 1262 Access Point so that it strengthens the WLAN while acting as a WGB the same time? Or would I have to use 2 Access Points for that task? Thanks in advance
Hi all,first post here, please be kind I need a method to perform a massive import of new SNMP community strings on 600 devices, and maybe if possible delete the old ones.Is there a way to do so using Cisco Prime ver 3.7? I cannot found a method thro...
So I was wondering how to address performance issues in a mostly switched environment?Are there any ideas or steps some of you could suggest.My only idea is to track down the taken links from a access-switch to the core router and looking at the stat...
i have a 2921 router; pointing at a syslog server. the router has a loopback interface configured as the source of syslog. the router's gigabit0/0 interface has been flapping. i can see the up and down events for link and line protocol in the router'...
I'm attempting to configure TACACS+ for my NetScout PFS Fabric Manager 4.3.1 (and managed devices). I have it working for login successfully, but I am unable to apply the correct roles to the account after authentication is successful. I basically on...
kindly i have problem that switch C9500-32QC that is working as border in SDA is reloaded without any reason or loggs , so kindly share your experience if you faced a similar problem all switches on the same rack are working fine------------------...
Hello, I am getting the following Warning message for my FTDs.."The number of access list elements generated for the access control policy exceeds the limit for this platform. Please enable Object Group Search on the device." How do i resolve this is...
Hello Experts,Our requirement is to schedule a reload on a router automatically when it generates memory fragmentation errors and becomes inaccessible over VTY lines.I read somewhere that this can be done using SNMP but I am not sure how.Can someone ...
Resolved! ASR 9901 Mounting Kit
Hello, I am looking for the 2P mounting kit for the ASR 9901 Router. An online search yields kits for ASR 9001 and I am not sure whether these would be compatible with the ASR 9901. See link here. Also, please explain what is the difference between t...
Resolved! Networking
Hello, I am trying to solve this network. It is a bit challenging. I am trying to configure static routing, dhcp, and ip helper address. My dhcp is not sending any address to my pc. My static routing is not working. I am not sure what I doing wrong ...
hellonow i have 4 switches each one has an SVI (192.168.1.0/24) , how can i get into telnet session from router "BGD" to all switches ?the switch subnet did not routed throw the routers (OSPF area 1 environment)i already do line VTY config on each sw...
