I Configure Cisco prime email notifications everthing is look good but When Devices Trunk port only shutdown does not sent email notifications but when I use no shutdown sending notification for down and up interfaces How can I solve this problem...
Forum Posts
I am having an issue when I tried to create a simple network from the pdf 2.1.1.5, I don't understand why this error keeps on popping up on the command prompt!I have already attached my zip file, I hope you could help me to resolve this as soon as po...
hello to you all, new here just trying to get some help ref / flash software for my AP.I am just a jo blogs home user try to find how to get hold of flash.any help I be most grateful, thanks for your time if you read this far.Neil. p.s hope my post i...
I had see this alert on CRS8 router, can any one help me to understand this log. log = LC/0/3/CPU0:Sep 6 05:19:46 KST: pse_pogo_driver[298]: %PLATFORM-CIH-1-ASIC_ERROR : pse[0]: A link-err error has occurred causing data corrected. 0x12610134 [th...
Resolved! EEM on 2960S LANBASE?
Howdy all. I'm hoping someone can help answer whether EEM is supported on a 2960S switch with LANBASE (not LAN Lite). I'm running 12.2(55)SE9 UNIVERSAL, which, according to Feature Navigator, supports EEM 3.2.When I try to configure event manager on ...
Resolved! Cisco to Mikrotik Trunk Configuration
Plz See the Attachment below
I have a dual-wan cisco RV345 router which is connected to two modems. I use it for Internet failover (dual WAN plus cellular modem). I tried to connect the Google wifi for it and I can't make it to work. The two modems are configured as bridge and t...
Resolved! Cisco Prime Notifications devices
Hi FriendsI am configured email notifications for my Cisco Switch and other devices . Prime send email notifications success but sending notifications from all port acces and Trunk port but I want sent from only trunk port so I create port group and...
Dear Experts, Kindly, review the attached Network Arch. as it explains what I am struggling to establish. I have an Industrial Network at a location-1 which I need to extend to Location-2.The bottleneck is, I have only 1 pair of Fibre available, whi...
Resolved! ccna ipv6 question
Hiim learning for the ccna and i have a couple of questions about ipv61. why do we need all these type of multicast and especially why do we need Link-local multicast address2. what is the scope and why we need them and are they address that only on ...
does SLAAC and DHCP can be used on global unicast / unique local or both ? thanks for the help
Resolved! regarding etherchannel pros and cons
etherchannel sounds like a feature that you would always want to be enabled, but im having difficulties to believe there arent any downsides to using it, but i couldnt find any online searching google.aside "wasting" additional ports that could be us...
Resolved! unable to ssh router 1921/K9
Hi all, Please help me to check my configuration on cisco router , I tried to setup ssh connection from outside link (interface Gi-0/0), but the network connect ERROR.May be the issue come from NAT but i did not know how to fix it yet My configurati...
Hi, I am having an issue with new devices; such as: laptops, tablets, and cell phones, get an IP address from my DHCP server. Other (already connected) devices that was able to connect to the network in the past is able to get an IP address and to t...
Hi all,sorry if this isn't the right forum. I tried asking the same question on the Cisco Press forum, whit no success. I have a question about the definition found in the CCNA R&S course: for peer-to-peer network I have read that one of its disavant...
