Can anyone tell me the steps in order to get my switches to log events into Cisco Prime, so effectively using prime as a syslog server. I want this for scenarios where I am going to distribute images to switches and want the logs to be sent to prime ...
Forum Posts
What are people doing out there for device IOS lifecycle management? We have Solarwinds, but I am not sure how efficient that product is for software management. I do think that DNA can do it but we do not have that product. So just seeing what peopl...
Hi All,I'm having issue with Cisco Prime GUI not loading on any browser.I ssh to the VM running Cisco Prime and ran a NCS Status and this is what I get.# ncs statusHealth Monitor is running, with an error.initHealthMonitor(): can not start DBFtp Serv...
What mechanism should try for below scenario.?
Hello guys, I need to setup 3 WAN ISP connections on my network, after getting service interruption issues on my main ISP, finally got approved to add 2 secondary ISPs, to complete a failover-redundant schema.My question is if two routers under GLBP...
I have a Cisco ASA 5505 that does not seem to have a bootable image in the / directory. It cycles through rommon mode, offering to pause/break the cycle and allow me to input the normal commands to recover an image via tftp. I have followed the pr...
Hi,I have some servers here that needed a more stable router than my WNDR3700 with dd-wrt could offer. I have never used the Cisco IOS before and am a gui lover by nature. After reading about the new CCP and its flexability I made the plunge. I have ...
Hi Customer wants to run reports on per AP: 1. Bandwidth utilisation 2. Application utilisation and breakdown 3. Client usage Is it feasible to run these on Prime Infrastructure? If so, what licenses is required?
Hello, I am currently working on creating an SNMP monitor in Solarwinds to report on when ADSL goes down on a router and it starts to use 3G/4G. The routers we have are Cisco ISR C887VAG-4G and Cisco ISR 887VAG2. Does anybody know the relevant OID t...
Hi folks, we are trying to use Ansible to automate/script many of the common ACI tasks. One use case is creating a L3out. There is an ansible module called "aci_l3out" which helps create the l3out config, BUT it does not carry with it the other sub-c...
After Upgrade our Firepower from 6.2. to 6.3 i was pleased to find out, that i'm now able to use FQDN Objects. But where can i find the DNS Settings to use this feature?
Hello team,Is there today at Cisco a tool able to map cisco equipment (models, IOS version, etc.) installed on a network ?Thank's.
hi dears, kindly help me as i have catalyst sw 9200,9300,9400 in my environment and i use forescout counteract for NAC so what are configuration needed to apply for switches.thanks
Can anyone suggest if CGNAT (Large Scale NAT) can be enabled for ASR1001-X and ASR1001-HX and how?
