Network Management

Hi,   I'm configuring this network with IP Phones (I have NOT done IP Phones before) in Packet Tracer 6.2, I have already done enough research on it without any result, the videos that I see have connected PC to Phone and then Phone to Switch and seg...

Hi all, I am looking for the MIB objects and OIDs for the snmp trap monitoring to the device below. ・Catalyst3850 Version IOS-XE 16.3.5b   I checked the MIB objects and OIDs at the following site.<MIB Locator>http://mibs.cloudapps.cisco.com/ITDIT/MIB...

I was wondering if i am able to distribute code from cisco prime to a 4507 with dual supervisors. And if i can would it push the code down to the secondary supervisor.     

Want to see if anyone knows if it is possible to receive source MAC from a netflow stream coming from a Cisco ASA 5555X. Also, any suggestions would be much appreciated. 

I need to be able to detect which route-map is applied to a BGP neighbor in an EEM script. For example:   if route-map PRIMARY is configured on neighbor x, then run the command "standby 80 prio 160" if route-map BACKUP is configured on neighbor x, ho...

How can I find the running Prime job via the Prime CLI?  Assuming there is a PID per each job that can be manually killed.  Ran a system reboot job that was reloading routers.  Prime said the job stopped or timedout but routers were still rebooting a...

HiI am writing about the Cisco 3850. With the sh env all command, Switch 1: SYSTEM TEMPERATURE is UNAVAILABLE. Switch 1: SYSTEM TEMPERATURE is OK OK? I want to know why this message comes up.   Switch 1 FAN 2 is OK Swi...

Is it possible to create a custom dynamic IOS software version Dashlet in Cisco Prime.  So idea is a user can select a device family and see software versions on that device familiy dynamically.  A visual on demand interactive dashboard for IOS versi...

Trying to use CLI Templates to push this command to a bunch of ISR4Ks but it has a yes/no prompt that needs a response so trying the #INTERACTIVE option but have not gotten it to work. Tried various permutations but they all fail.  There is not much ...

Hello everybody !    I need help to understand why my applet does not work. It is simple as it should be as below (for testing purposes, later on if it works I am planning to go deep on that) :   event manager applet test event syslog pattern "Ethern...

Hi Router Experts,   Could you please help me create a IP Traffic Export profile? Am I missing something on my 4331 router?   Trying to create a profile but router doesn't know that command.   RTR(config)#ip tra?% Unrecognized command   Thanks, Orthi

Hello, I already changed the SSH service port from 22 to 2222 in 7609(Using command and ACL). And I checked the block connection from another service port.   However, the management interface seems not affect this configuration. Because it is possibl...