Network Management

Hello all, Is there a way to change the default snmp description field. The description field is not editable by default on the cisco switches and It send the swicth details , IOS  version TAC URL  .. etc . If I want to control what information will...

Hi, 1900 series router at site was power rebooted. No issue with power supply as other network devices up for more than a month. below are logs, wondering why it was rebooted. CIDBOI10-LAMR-RTR-1 uptime is 10 hours, 53 minutesSystem returned to ROM...

We are trying to delete a device from Cisco Prime Infrastructure 3.0. When we try to delete it from inventory we get the following error:         Delete Device(s) Failed: xx.xx.xx.xx. Please see ifm_inventory.log to get initial information. Please c...

I have  CPI 3.1 after changing the admin password i'm not abele to login via ssh with the two passwords: what i putt during the setup and the password i change , however via the console i'm able to login with password that I determined during the set...

Hi We are using Cisco Prime Infrastructure for NetFlow collection. What I see is that only certain ports are named correctly in the DashBoard, meaning that quite a few comes up as unknown (see attached picture). Is there a place where I can "map" un...

I cannot make this work no matter what I do. This picture shows my intended goal. but I cannot ping between different devices. If I'm on VLAN 130 (192.168.130.77/24) with a pc plugged a port that is a member of VLAN130UP/VLAN132 .... I cannot ping a ...

Cisco Prime Infrastructure rollback same archive configuration for a ASR 1004 to four different ASR 1004 devices.  Causing a network outage.  Was able to do a comparison of configurations in archive for each device to restore correct configurations. ...