Network Management

Hi,I am using EEM to trigger the following commands on a set event:action 1 cli command "enable"action 2 cli command "tclsh flash:mytcl.tcl"In my tcl script I am using the command 'after' to sleep for a specific time.What I notice is that the script ...

HI,Using Cisco Network Assistant... Can I find out the IP of a host which is connected to port 6 in my Catalyst 2960-24TC...Many thanks in advance...

Hi,I am trying to play around with NCS.I have ESXi box (4.1 and 5) and have tried using both ver 1.0 and 1.1 of the appliance.The error i get on boot up isFailure during Network Control System startup. Check launchout.log for detailsHow can i check t...

Hi,Currently, we are running LMS4.2 and NCS 1.1 (with wireless) license. Do we have to purchase the separate license for prime infrastructure?Thanks,Kerim

We are wanting to use local database users to authenticate our SSH connections to our 6500 cores.We have added the usernames and password into the 6500 using username anameduser password astrongpasswordorusername anameduser secret astrongpasswordWe w...

    I have deployed some CLI templates I have created to configure multiple local accounts on some switches. However the cli templete only appears to accept conf t commands, it will not accept 'write mem' or 'copy run start' at the end to save the al...

I'm looking for a reference document, describing what built in variables are used in the LMS 4.2 Template Center, like in PI the DB variable reference.Most importent is the current $Management_IP_Adresse in the run loop of the template. But an overal...

Is it possible to run templates from Template Center against a parameter file instead of interactive setting the variables analogue to compliance base line templates?If yes where can I find a documentation, how to deploy template center templates wit...

Hi,Product: Cisco Prime NAM Appliance 2304Version: 5.1(3)Problem: We only can see MAC address on Hosts table in NAM, not IP address.Does anyone know what happen and how to fix it?Thanks!!!

Sorry if I've lumped too much stuff into one post.I am rejoining the group using my personal email address as my work address is unfortunately something that could potentially change (hopefully not soon, but we never know). I've been an online member...

Hi @all,We just ran into Problems applying Autonomous AP Configuration Template to APs.Last few days all worked like a charm. Applied Configuration Changes to about 500 APs without problems.Since yesterday we get an Error if we click on "Apply to Aut...

Hi,in LMS 4.x and DFM you can unmanage a specific interface, port or other component like cpu, psu or sensor of a device.Can't find that functionality in PI 2.0, is it available there?Thanks,Fredrik

I am wanting to have my isr's send an email when a certain number of deny's occur on an ace.  So if i have a particular ace set up to log when tcp 3389 denied.  Then the eem applet or script would track when that deny entry happens.  When the deny hi...

I currently have an issue distributing software via the software repository in Cisco Prime 4.1.For any IOS that I try to distribute, I get the following error...SWIM1001: The input parameters to the Image Distribution/Image Import/Image Activate are ...