Network Management

I try to implement Cisco LI MIB on a 7406 VXR chasis. I issue the command from the mediation devicemerlyn@revan ~ $ snmpget -v3 -u liuser -a MD5 -A password -l authNoPriv 192.168.111.1 cTap2StreamInterceptEnablewithin the documentarion cTap2StreamInt...

Hi,Customer has an 2 LMS 2.6 servers :- Master  with RME - Slave with RME and Campus       He has lost all  device from dcr on master, so on slave too.When we try lsdcr on master we can see that dcr is empty.How can we get back devices, more that 400...

Hello,I need help for installing DCNM V6.1.2 with PostGreSQL bundle. I am trying to install the product on a Windows 2008 R2.I use RDP with /console to connect to the DCNM server. Then, I use a local admin account. I stopped the Anitivirus. The insta...

Hello,I have a question:In Cisco Prime LMS 4.2, I get "OutOfRange" events on high temperature threshold.For example, a device has 46.0 C while the high temperature threshold is 45.0 CI tried to change the high temperature threshold but the only optio...

Hello Community,Can someone please tell why this access list wont work. I can still ping 150.2.2.2 from R1, with ip address 172.28.38.1 even though its in /24, however I can't ping from R4 with ip address 172.28.38.1 even its in /16 subnet. Extended ...

Hi EveryBodyI am using Prime LMS 4.2.2 software to archive configuration for my cisco Network Device  switch and firewall . All works fine   except for  two new Cisco ASA 5525 and ASA 5545 ( Software Version 8.6.1.2 ) . I have already checked credent...

All,I have a Cisco Configuration engine that we use to send out configuration updates to our fleet of field routers? Although most of the other commands work via update config feature except for the reload command.I need to send a reload command in o...

Is there a tcl script or EEM configuration where I can filter syslog messages from my switch to syslog server. My syslog server is filling with the 802.1x logs and I want to filter these if possile. I have Cisco 4507s with SUP6 and SUP7  using 151-1....

Hi,I have installed LMS on Windows server local disk (D drive) with 40GB of storage and I want to 'move' the NMSROOT directory to SAN storage (E drive) with 100GB of storage.I tried stopping all services and swapping the drive letters around but when...

Hi NetproHow to backup the configuration of Cisco devices managed by LMS 4.2 and store it in Folder , than restore it once it need itthanksjamil

Hiwhat does it mean this event name ExceededMaximumUptime?thanks

HiHow to Adjust the time of my LMS 4.2 according to our Domain Controller just for time accurate of the event?thanksibrahim

Hey guys,You'd know if any of CiscoPrime module has the features of ACS?Thanks!

Hi GuysAre there any events I could catch to trigger a script for new calls as they pass through a CUBE?I'm wanting to set up an alert based on a certain number been dialed.TaPeter