Network Management

Good morning, requiring some assistance for bulk loading conference spaces on my CMS 1000 server.  I am currently running the VM application Meeting server v3.0 on a CISCO UCS-c220-m5 server.  I can build individual spaces and passcodes, and while th...

Good day,I require some Assistance.I have Configured Radius Authentication on all of our Cisco Switches, but I have Randomized Issues that I am not sure how to fix. The Authentication works 100% on our Domain computers.With some computers we have a I...

I have been stuck at this assignment for a week now. No matter what I try even redoing the whole thing serveral time, I can't seem to figure out why the DHCP server is not working for the PCs. I would really truly appreciate if you can help me find o...

Hi. I couldn't find in PI how to view a list of all interfaces on all switches at what speeds they actually work with automatic speed adjustment on the port (10/100/1000)?Not 5/10/15 switches, as on dashboards, but fromall switches on the network. an...

I have created a vpn tunnel between the asa firewall (ikev1) and the cisco router. the asa subnet is 192.168.100.0/24, the router subnet is 10.100.0.0/24. The VPN works fine and they can communicate with each other. But I can't NAT the 192.168.100.0/...

Hello,I am trying to upgrade Cisco Prime from version 3.8 to 3.10, but my CLI access is denied. The web access is working fine, but I canot Access the CLI using tools like PuTTY, for example. Could you please assist me in resolving this issue?Thank y...

Other than the obvious difference of "Smart Software Manager On-Prem" being supplied as an .ISO image and "Smart Licensing Utility" as either a Windows or Linux application, what's the difference?  Why would I use one over the other.  Both are still ...

Hi,With stateful ASA FW pairs you configure interfaces with primary and standby IPs.Must standby IPs necessarily be within the same LAN as primaries?If so, must they be within the same VLAN? Or can routing be used to interconnect them instead?For MGT...

Hi, if I have remove a client using Cisco Prime Infrastructure how do I re-enable or allow it back in to the network.

Hello Cisco Prime experts,after upgrade to V3.10.4 Update 02 our licensing connection to our internal Smart Software licensing Server is broken.All licenses are shown in evaluation mode!Release Notes state the following:Starting from Prime Infrastruc...

Hey Cisco community,I found some issues in the current CISCO-LWAPP-AP-MIB. I downloaded the newest one from https://cfnng.cisco.com/mibs and even there the errors exist. So I will just post them here so it will maybe reach the relevant developer / en...

Is there any way by which we can find the number of routes and number of received routes using snmpget.OID - 1.3.6.1.4.1.9.9.187.1.2.4.1.1 gives us information about the routes accepted after appling filters. But is there and OID for received-routes ...

We were given the following details:The L2 PVLAN has been created:PVLAN- 123Name: pvlan-XXX-L2Primary IP: x.x.x.131/27Subnet: 255.255.255.224Gateway: x.x.x.129 However, when we plug in the router's WAN port to the PVLAN port in the office (and config...

First time working with EPC. Here's the command I'm using below.monitor capture pcapname access-list pcapACL interface int# both file location flash:filename.pcap buffer 20I have a couple questions. First question, even though I'm stating the file to...