Network Security

Hi.. SSH Server on Internet <--- { Wan Router <--- ASA5500 <--- LAN <- SSH Client }. SSH client in our network want to access to SSH server on the Internet.How can I configure to allow ssh access on ASA5500.

Hi,   After i put my username & password im unable to login to ASDM. No change at config. Attached is the screenshot. Appreciate u help.

Hello,   We are runnig ASA 5510 with 9.0.1 as vpn gateway and we recently found out that it is possible to query public ip address for example for nbtstat via udp for connected vpn clients, at least the asa answer on public ip on udp 137 and allow ac...

Hi.. I have a ASA 5508-X. Outside interface IP is 203.81.x.x and Inside interface IP is 10.10.x.x. I want to access from a ssh client (eg: 10.10.1.9) in inside network to ssh server (eg: 64.20.8.42) on Internet. How can I configure to allow ssh acces...

So I setup 3 different contexts. I am wanting to configure the same vlan id, on each of these contexts. An error comes up displaying, this vlan is already used on port such n such. If each context is it's on firewall, why does it give this error? Can...

The following is the current running config. Any suggestion on how to get it working is greatly appreciated. I would like to access my 2016 domain server and IIS behind ASA5510 firewall. Thanks for your collaboration once again.ASA5510# show run: Sav...

Dear Friends,   We are unable to bring new asa in to lan, hence pleas suggest me,   ciscoasa# more system:run: Saved : : Hardware: ASA5508, 8192 MB RAM, CPU Atom C2000 series 2000 MHz, 1 CPU (8 cores): Written by enable_15 at 11:19:00.049 UTC Mon Jan...

Hi Network Guru,   I would like to seek for some help, as I encounter problem configuring WiFi access in ASA 5506W. I already created 2 SSID and broadcast it on our network, but the problem is I can connect to the SSID's but I'm unable to get IP addr...

hi all,   i have one cisco 5506-x purchased with firepower and i want to introduce to my network without any changes. i have cisco 2901 router with 2 vlans sub interfaces in dot1q interfaces. now i want to connect asa as transparent mode. my question...

Hi,   I have Cisco ASAv running in my AWS environment. Unfortunately it is not accepting the password for enable mode. I have the encrypted password in my startup config and would like to know if I can decrypt it in any way.   Any help greatly apprec...