Network Security

Hi People,My VPN Client is running on the PIX Version 6, how can i set the PIX to use local usernames and passwords instead of  Radius auth ?Follow my conf :aaa-server TACACS+ protocol tacacs+ aaa-server TACACS+ max-failed-attempts 3 aaa-server TACAC...

We created following network configuration:-central L3 3750 stack acting as VTP server for VLANs (all vlans are created here), enabled vlan routing, dhcp server for some VLANs, trunked ports connecting L2 2960 switches.-several L2 2960 as VTP client ...

Hi, please, could I upgrade the 8.0(5) IOS version to a major version?Actual:ASA 55401 Gb RAMIOS 8.05(5)ASDM 6.3(1)This is because my secondary standby unit is reporting "LU allocate xlate failed". I don't understand why it is happening casue my curr...

I just want to verify if the following is working properly: - Under Configuration > IPS > Sensor Monitoring > Time-Based Actons > Host Blocks is configured properlyI have entered in a few hosts to be blocked and I notice the following: - Under Connec...

Hi, I am trying to let ZFW inspect my dual-stacked hosts on my asr1001, but it does not work. It seems that ZFW just ignores ipv6-traffic and lets it pass uninspected. "sh ver" says:Cisco IOS Software, IOS-XE Software (X86_64_LINUX_IOSD-UNIVERSALK9-M...

Hello,i'm in need of some help here, we have multiple public ip.1 is use for our ASA Outside interface (.179)1 is use for PAT for SMTP with our mail server (.178)I'm not able to resolve my problem, our MX Record and RDNS is setup to use (.178) but ea...

I currently have an ASA5510 that has it initial IP block being provided by the DC, recently the company has had a need for a new IP block which has been given to us by the same DC but is also discontiguous from our original block.  I have ponder best...