Network Security

Hi,After the port taken into control under the profile & bounced it shoud change the vlan to the authentication vlan which is not happening. I have configured everythng as per best of my knoldge.Can anyone pls guide me if anywhere I am missing someth...

Hey,i have a little prob in my test-lab.The Lab: pc -> switch1 -> asa -> switch2 -> access pointI configured the devices and after they booted, i can ping all devices from the Pc ( AP, FW, Switch2 behind the asa )After about 20 Pings i get ping time...

HiI have received 7 ASA (1*5510 and 6*5505) with the PAK associated for security plus licenses.I connected to the cisco web site to generate the activation keys.I received 5 activation keys by email but 2 are still missing and now I cannot use the PA...

Here is the deal. We dug up an old Cisco PIX 501 that has been previously activated and used sometime way back when. I looked through the config and noticed a lot of commands that vary from what I've learned on the CCNA track. I saved the old conf...

Hi guys,what is the difference between static nat & alias?is it that in alias ip addresses can be in any interface?just i cant no understand when to use alias command? and why?Regards,

Is there a way I can allow connection from inside the firewall to one of my public IP which has a static NAT?I connect out from internal and want to connect via port 80 external on a second IP mapped back to an internal address? Is it just a case th...

Hi,I want to use our SNMP server to monitor our IPS modules CPU and Memory, does anyone knw the OID(s) I need to use?Thanks

Dear all,I am facing strange problem with 6500 IDS module.Management port of IDSM is up and Data port 2 Operational Mode: down.When i check traffic on this port it is one way only.I can able to ping IDSM management IP but when i try to telnet it give...

Hi,I have two 6509 each with FWSM module. we will configure this in active/standby. We want to configure 10 vlans for inside and 5 vlan for outside will connect to my mpls. internet gateway cloud. I don't want any restriction between my inside vlans...

I wonder if anyone can tell me the best way to configure ISP redundancy like can be done in checkpoint, not to confuse with device redundancy Many Thanks Mark

Hi,I have a Cisco vpn client for connecting to clients network. The client gets authenticated and is able to connect to VPN. But none of the network applications like remote desktop are working.I am able to telnet on 3389 for that IP but remote doens...

Looking at the diagram, is it possible to ssh from the WinXP machine to both Eth0 (IP address 192.168.2.2) and Eth1 (IP address 192.168.3.2)? If it is possible,how do I go about doing it?Thanks.