Network Security

We are experiencing poor network performance when connecting from hardware VPN sites. VPN sites have Cisco Hardware VPN client 3002 which terminates to Cisco 3005 VPN concentrator. Geting upload/download speeds of 355/484kbsp from VPN to surewest.com...

Hi all, I use Cisco VMS 2.1 and update to Cisco VMS 2.3 to manage IDSM (version 5) but now I see an error. I have a license of Cisco VMS 2.1 and when I update to Cisco VMS 2.3, I use the same license file but I see the error in Cisco VMS "Error about...

I need to migrate some customers from Checkpoint over Cisco Pix firewalls, NOT ASA.Currently in the checkpoint security policy, we onlyallow snmp version 2 and version 3 to traverse thefirewalls. Furthermore, we also allow only ssh version 2 from tra...

Not sure if this is the right forum for this questions. I have a vpn concentrator 3005 with it's private interface connected to a dmz interface on my pix. The public interface to a hub hanging off my router facing the internet.I have a vlan set-up on...

Hello,An existential question:Why the FWSM doesn't support hsrp or vrrp ? Is it possible to see something like that in the future ?In a robust solution, 2 routers in front of the blade (in multi-mode) with 2 routers behind the blade need to peer BGP ...

Good day folks,I have tried hard to find examples for the following scenario without luck. Here is my IOS (not PIX) problem:Because of overlapping addresses problems, I have to allow internal clients to connect to servers through a router with static...

Hi;Can I setup multiple context A/A setup on ASA 5520 , and have the fastethernet configured for DMZ access , and Can A/A been setup on DMZ side ?

Hi There,Can source-based routing be achieved in ASA, as in routers with route-maps, using the policy and class maps configuration?Regards,Haitham

I am going upgrade my Cisco 3660 Router by one Cisco 3845 ISR, I need Firewall Feature Set in my new router but I have to use the NM-1A-E3 used actually. Is compatible the CISCO3845-SEC/K9 Bundle with IOS Advanced Security for the NM-1A-E3 module? Th...

Is there any change required for intervlan comm. on FWSM with same sec levels other than usual conf like sec level,ip add,nameif on the specific int/vlan.

how does intervlan comm. happen in FWSM.

Hi all, I use IDSM-2 (IPS version 5), now I want to reset all of signatures to default. You can show me the command to do. Thank you very much

On our PIX515 6.2(4) we had to do "no fixup protocol ftp 21" to prevent our ftps from hanging. How can we do the equivalent command in the ASA 7.2(1)? I've seen posts about the "inspect ftp" in the global policy, and other posts about modular policy ...